Abstract:Methodologies of API 579 have been widely accepted as the de-facto standard guideline for fitness for service assessment on crack-like flaws in pressure equipment. For different purposes and needs, the evaluation is divided into three levels, from critical length estimation in level 1, use of the failure analysis diagram (FAD) in level 2, to performing finite element stress analysis in level 3, that is from simplified to accurate. It is generally considered safe as long as the crack is smaller than the critical crack, but not all of them are actually the case. Therefore, it is very important to study the physical meaning behind the critical crack and understand the conservativeness of it.In this study, numerous examples of critical cracks determined according to API 579 Level 1 were put into Level 2 analysis for comparison. Each case is mapped onto the FAD of level 2 analysis to see its position and distance from the borderline between safe and danger zones. A huge amount of examples covering the majority of possible scenarios, including the geometry, thickness, inner diameter, pressure and half-length of the flaw, depth of the crack, crack tip and crack bottom, as a whole, there are 960 cases to be analyzed.Results show that cracks on the circumferential direction of the cylindrical and spherical vessels are distributed tightly in a small area far from the borderline on the FAD diagram. In these cases, the vessel is actually not as dangerous as the critical crack implies, since most of the points lie quite far from the danger zone. As for the longitudinal cracks of a cylindrical vessel, the results are scattered around, and three data points are located outside the allowable zone. The peculiar results are partly due to a discrepancy of interpolating procedure as the influence coefficient is being computed. Through this study, it is also found that the cumbersome process of estimating the critical crack length can be greatly simplified for longitudinal cracks in a cylindrical vessel.

Finite Analysis and Experiment Study on MFL Testing in Pipeline's Cracks

Numerical Analysis of Buried Pipe Characteristics

A Simplified Analytical Solution of Pipeline Response under Normal Faulting

Experimental and Numerical Analysis of the Impact of Corrosion on Pipeline Failure Pressure

The Magnetic Flux Leakage Analysis Of Cracks Based On The 3d Finite Element Method

EXTEND FINITE ELEMENT NUMERICAL SIMULATION FOR CRACK PROPAGATION OF FIBER CONCRETE

Application of Computer Finite Element Simulation to the Quantitative Inspection of Flaw MFL

1003 Experimental Study on Limit Load Criterion for Pipe with Crack Modelled in Its Shape

A Numerical Analysis with Scaled Boundary Finite Element Method to Simulate Mixed-mode Crack Propagation for Concrete Beams

Fracture and Fatigue Assessment on Submarine Pipelines with Crack Damages

Transient Simulation Analysis on Magnetic Flux Leakage Detection of Cracks in Long-Distance Oil and Gas Pipeline

A Novel Crack Quantification Method for Ultra-High-Definition Magnetic Flux Leakage Detection in Pipeline Inspection

Fracture mechanics analysis of gas pipeline with circumferential crack under the action of transverse landslide

A Finite Element Model for Crack Arrestor Design in Gas Pipelines

Using Finite Element Method for Stress-Strain Evaluation of Commonly Used Buried Pipelines in Fault

Calculation of Stress Intensity Factor for Annular Double Cracks on Inner Surface of Pipeline

MODELLING THE CRACK PROPAGATION AND ANALYSIS OF THE INCLINED CRACK PATH IN THE PIPE WITH THE EXTENDED FINITE ELEMENT METHOD AND MOLECULAR DYNAMICS METHOD

The FEM Simulation and Full-Scale Blast Tests for Crack Deceleration in Gas Pipeline

Experimental and Numerical Studies on Mechanical Behavior of Buried Pipelines Crossing Faults

The Study on Crack Dynamic Propagation in the Rich Gas Transmission Pipelines

Determination of the critical length of the crack-like flaws and its effect on safety