Abstract:Embedding a thermoelectric generator (TEG) in a biological body is a promising way to supply electronic power in the long term for an implantable medical device (IMD). The unique merit of such a method lies in its direct utilization of the temperature difference intrinsically existing throughout the whole biological body. Therefore, it can resolve the service life mismatch between the IMD and its battery. In order to promote the stability of the power-generation capacity of the implanted TEG, this paper is dedicated to study a low cost and highly safe practical pattern of implanting a TEG driven by the radioisotope fuel into a human body. Recurring to the thermal energy releasing during disintegration of the radioactive isotope, it can guarantee a marked promotion in the temperature difference across the implanted TEG, consequently supplying enough power for the IMDs. A bioheat transfer model with or without a large vessel is established to characterize the feasibility and working performance of the method. The numerical simulation and parametric studies on tissue status, device properties, and environmental conditions revealed that, no matter in what conditions, the implanted TEG driven by the radioisotope fuel can always offer a much higher energy output than that provided by body heat alone. Meanwhile, in vivo/surrounding environment, isotope conditions, and intentional skin surface cooling also exhibit a direct influence on the temperature distribution of the implantable TEG and thus affect the working performance. Coordinating with the intentionally imposed cooling on the skin surface, the maximum TEG power can reach several mW, which is strong enough to meet the power consumption of the IMDs. These results were expected to be a valuable reference for designing an implantable TEG, which may actually be used in future clinics.

Animal Experiments on Implanted Thermal Electricity Generator

Suitability of a thermoelectric power generator for implantable medical electronic devices

A Prototype of an Implantable Thermoelectric Generator for Permanent Power Supply to Body Inside a Medical Device

Evaluation on the Power-Generation Capacity of an Implantable Thermoelectric Generator Driven by Radioisotope Fuel

Implantable passive and wireless telemetering system based on SAW temperature sensor

Implantable Electromagnetic Induction Power Generation Based on Human Kinetic Energy Method

Evaluation Of The Power-Generation Capacity Of Implantable Thermoelectric Power Generator Driven By Radioisotope Fuel

Design and Fabrication of Wearable Thermoelectric Generator Device for Heat Harvesting

Wearable Thermoelectric Generator with Copper Foam As the Heat Sink for Body Heat Harvesting

Development of an intravascular heating source using an MR imaging guidewire.

Subcutaneous Power Supply by NIR-II Light.

Design of a Wearable Thermoelectric Generator for Harvesting Human Body Energy

Thermal Analysis of Injectable, Cellular-Scale Optoelectronics with Pulsed Power

THE APPLICATION RESEARCH OF HEAT SOURCE AND HEAT SINK IN MICRO (MINI) THERMOELECTRIC DEVICE

Wearable Electronics Based on the Gel Thermogalvanic Electrolyte for Self-Powered Human Health Monitoring

Evaluation of the Power-Generation Capacity of Wearable Thermoelectric Power Generator

High‐Performance Self‐Powered Flexible Thermoelectric Device for Accelerated Wound Healing

Self-powered Implantable Electronic Medical Devices Research Based on Triboelectric Nanogenerator

In Vivo Self-Powered Wireless Cardiac Monitoring Via Implantable Triboelectric Nanogenerator.

Ultra-low frequency magnetic energy focusing for highly effective wireless powering of deep-tissue implantable electronic devices

Safety Study of Implant Wearers in MRI RF Field Environment