Kimberlite Petrogenesis: Insights from Clinopyroxene-Melt Partitioning Experiments at 6 GPa in the CaO-MgO-Al2O3-SiO2-CO2 System

S Keshav,A Corgne,GH Gudfinnsson,M Bizimis,WF McDonough,YW Fei
DOI: https://doi.org/10.1016/j.gca.2005.01.012
IF: 5
2005-01-01
Geochimica et Cosmochimica Acta
Abstract:In this experimental study, we examine the mineral-melt partitioning of major and trace elements between clinopyroxene and CO2-rich kimberlitic melts at a pressure of 6 GPa and temperatures of 1410 degrees C and 1430 degrees C. The melts produced contain similar to 28 wt% dissolved CO2, and are saturated with olivine and clinopyroxene. To assess the effects of temperature, crystal and melt compositions on trace element partitioning, experiments were performed in the model CaO-MgO-Al2O3-SiO2-CO2 System. Our results reveal that all the elements studied, except Al, Mg, Si, and Ga, are incompatible in clinopyroxene. Partition coefficients show a considerable range in magnitude, from similar to 10(-3) for D-U and D-Ba to similar to 2.5 for D-Si. The two experimental runs show similar overall partitioning patterns with the D values being lower at 1430 degrees C. Rare earth elements display a wide range of partition coefficients, D-La (0.012-0.026) being approximately one order of magnitude lower than D-Lu (0.18-0.23). Partition coefficients for the 2+ and 3+ cations entering the M2-site exhibit a near-parabolic dependence on radius of the incorporated cations as predicted from the lattice strain model. This underlines the contribution made by the crystal structure toward controlling the distribution of trace elements. Using data obtained in this study combined with that in the published literature, we also discuss the effects that other important parameters, namely, melt composition, pressure, and temperature, could have on partitioning.Our partition coefficients have been used to model the generation of the Group I (GI) kimberlites from South Africa. The numerical modeling shows that kimberlitic melts can be produced by similar to 0.5% melting of a MORB-type depleted source that has been enriched by small-degree melts originating from a similar depleted source. This result suggests that the source of GI kimberlites may be located at the lithosphere-asthenosphere transition. Percolation of small degree melts from the asthenosphere would essentially create a metasomatic horizon near the bottom of the non-convecting sublithospheric mantle. Accumulation of such small degree melts together with the presence of volatiles and conductive heating would trigger melting of the ambient mantle and subsequently lead to eruption of kimberlitic melts. Additionally, our model shows that the GI source can be generated by metasomatism of a 2 Ga old MORB source ca. 1 Ga ago. Assuming that MORB-type mantle is the most depleted source of magmas on earth, then this is the oldest age at which the GI source could have existed. However, this age most likely reflects the average age of a series of metasomatic events than that of a single event. Copyright (c) 2005 Elsevier Ltd.
What problem does this paper attempt to address?