Abstract:This work introduces a two-channel time-interleaved (TI) continuous-time (CT) 3(rd)-order delta-sigma modulator (DSM). It uses the information from one complete channel to predict the other channel based on the extrapolation principle. Note that, Cascaded Integrator of Distributed Feedforward (CIFF) topology is selected for the loop filter for the following reasons: 1) it could reduce the number of required feedback DACs as much as possible; 2) it allows to implement the zero optimization for the TI DSM such that the performance could be further improved. Furthermore, we employ the technique of error correction to address the issue regarding the delay-free feedback path, which originates from the extrapolating TI DSM. We present the derivations of the target TI CT DSM starting from a single-channel discrete-time (DT) DSM, while the compensation for excess loop delay (ELD) is considered. Fabricated in 65nm CMOS process, this modulator achieves an equivalent output sampling rate of 800MS/s, while the analog channel operates at 400MHz. It exhibits a signal-to-noise and distortion ratio (SNDR) /spurious-free dynamic range (SFDR)/dynamic range (DR) of 75.5dB/89.7dB/79dB over a 10MHz bandwidth. The total power consumption is 33.73mW from 1.2v/1.8v power supplies. It results in a Schreier Figure of Merit (FoM) of 163.7dB based on DR.

Effective Design for CRFF Sigma-Delta Modulators Using Inverters Based on 0.13μm CMOS

Effective Design for CRFF Sigma-Delta Modulators Using Inverters Based on 0.13<Emphasis Type="Italic">μ</Emphasis>m CMOS

A Sigma-Delta Modulator with Residual Offset Suppression

A 0.18 μm Single-poly CMOS ∑-△ Modulator for Digital Audio Applications

An Audio Cascaded Sigma Delta Modulator Using Gain-Boost Class-C Inverter

A Σδ Modulator Using Gain-Boost Class-C Inverter for Audio Applications.

Modeling of a 200 KHz Bandwidth Low-pass Switch-capacitor Sigma-delta DAC with a Raised Spur-free Modulator

Design of an Area - efficient High- order Leapfrog Delta- Sigma Modulator

Behavioral Modeling of Third- order Cascaded Sigma - delta Modulators

Two effective single-loop high-performance sigma-delta modulators based on 0.13µm CMOS

A 16-bit 312.5-kHz bandwidth fourth-order one-bit switched-capacitor sigma-delta modulator

Design Of A 5gs/S 200 Mhz Bw 74.8 Db Sndr Continuous-Time Sigma Delta Modulator In 28nm Cmos

A 0.8-V 230-$\mu$ W 98-dB DR Inverter-Based $\Sigma \Delta$ Modulator for Audio Applications.

An Area-Efficient Multi-Bit Sigma-Delta Modulator

A Low-power High-resolution Sigma-Delta Modulator

A High-Performance,Low-Power ΣΔ Modulator for Digital Audio Applications

Analysis and Design of Continuous-Time Incremental Sigma-Delta Modulators with Extended Counting Technique

A Two-Channel Time-Interleaved Continuous-Time Third-Order CIFF-Based Delta-Sigma Modulator

A Low-Distortion Fourth-Order Bandpass Sigma-Delta Modulator Using Double-Sampling Technique

Design of a High-speed Wide-band Continuous-Time Delta-Sigma Modulator

An Improved Single-Loop Sigma-Delta Modulator for GSM Applications