Abstract:Ordinary Portland cement (OPC) is the most common curing agent for solidification/stabilization (S/S) of fly ash (FA), however, the treatment is not efficient. This study aims to investigate the S/S of FA with the modified calcium aluminate cement (CAC) as a binder. The modified CAC was obtained by adding sodium dihydrogen phosphate (NaH 2 PO 4 ), an inorganic chemical agent, and sodium diethyl dithiocarbamate (DDTC), an organic chemical agent, into CAC. Toxicity characteristic leaching procedure and unconfined compressive strength (UCS) test were carried out to evaluate the treatment effect of the proposed binder. The sequential extraction procedure (SEP), X-ray diffraction and scanning electron microscopy (SEM) were used to study the chemical speciation , mineralogical characterization and microstructure of the solidified/stabilized FA. The treatment results of pure CAC and OPC showed that the immobilizing efficiency of CAC was much higher than that of OPC. When curing with 10% CAC and 1% DDTC, the leaching concentrations of Cd, Pb and Zn decreased to 0.06, 0.12 and 18.95 mg/L, respectively. With the combination of 10% CAC and 0.5% DDTC + 0.5% NaH 2 PO 4 , the leaching concentrations of Cd, Pb and Zn were 0.12, 0.16 and 10.21 mg/L, respectively. The regulated leaching limits can be met under both of the above combinations. The UCS of the solidified body was 3.02 MPa under the combination of CAC + NaH 2 PO 4 + DDTC, which was much higher than the 1.34 MPa of the CAC + DDTC combination. SEP shows that most unstable forms of Cd, Pb and Zn in FA were converted to stable forms after the treatment by modified CAC. The immobilization mechanisms of the proposed binder included encapsulation of heavy metals and the formation of heavy metal complexes or precipitate. The CAC hydration products, the precipitate and complexes reduced the pores in FA particles and therefore reduced the leachability of heavy metals. This study demonstrated the effectiveness of the proposed modified CAC as a binder for FA treatment. As NaH 2 PO 4 is inexpensive than DDTC, the scheme of CAC + NaH 2 PO 4 + DDTC is recommended.

Alkali-activated Complex Binders from Class C Fly Ash and Ca-containing Admixtures

Performance and Mechanism of Alkali-Activated Complex Binders of High-Ca Fly Ash and Other Ca-Bearing Materials

Alkali-activated binder based on red mud with class F fly ash and ground granulated blast-furnace slag under ambient temperature

Manufacture of Alkali-Activated and Geopolymer Hybrid Binder (AGHB) by Municipal Waste Incineration Fly Ash Incorporating Aluminosilicate Supplementary Cementitious Materials (ASCM).

Solidification/Stabilization of Waste Incineration Fly Ash by Modified Calcium Aluminate Cement

A Design Method of Alkali-Activated Binder Based on All-Solid-waste

Strength, Shrinkage and Early Age Characteristics of One-Part Alkali-Activated Binders with High-Calcium Industrial Wastes, Solid Reagents and Fibers

Transforming MSWI Fly Ash into Low-Carbon and High-Compatibility Composites Via Designed Calcium Sulfoaluminate-Based Binders

Preparation of Alkali Activated Cementitious Material by Upgraded Fly Ash from MSW Incineration

Mechanical Property And Structure Of Alkali-Activated Fly Ash And Slag Blends

Fresh and Hardened Properties of Alkali-Activated Fly Ash/slag Binders: Effect of Fly Ash Source, Surface Area, and Additives

Setting and Hardening Behaviour of Alkali-Activated Landfilled Fly Ash–Slag Binder at Room Temperature

Designing Low-Carbon Cement-Free Binders for Stabilization/solidification of MSWI Fly Ash

Modification mechanism of flue gas desulfurization gypsum on fly ash and ground granulated blast-furnace slag alkali-activated materials: Promoting green cementitious material

A novel binder prepared from municipal solid waste incineration fly ash and phosphogypsum

An Lc3-Type Binder Produced with Marine Clay and Municipal Waste Incineration Fly Ash

Properties and Microstructure Development of Alkali- Activated Coal Bottom Ash and Titanium- Extraction Tailing Slag Binder

Shrinkage Mitigation, Strength Enhancement and Microstructure Improvement of Alkali-Activated Slag/fly Ash Binders by Ultrafine Waste Concrete Powder

Utilization of Calcium Carbide Residue as Solid Alkali for Preparing Fly Ash-Based Geopolymers: Dependence of Compressive Strength and Microstructure on Calcium Carbide Residue, Water Content and Curing Temperature

Manufacture of alkali-activated cementitious materials using municipal solid waste incineration (MSWI) ash: Immobilization of heavy metals in MSWI fly ash by MSWI bottom ash

Stabilisation/solidification of municipal solid waste incineration fly ash by phosphate-enhanced calcium aluminate cement