Thermal-Induced Microstructure Deterioration of Egyptian Granodiorite and Associated Physico-Mechanical Responses
Mohamed Elgharib Gomah,Guichen Li,Ahmed A Omar,Mahmoud L Abdel Latif,Changlun Sun,Jiahui Xu
DOI: https://doi.org/10.3390/ma17061305
2024-03-12
Abstract:Mineral transformations often induce microstructural deteriorations during temperature variations. Hence, it is crucial to understand why and how this microstructure weakens due to mineral alteration with temperature and the correlated physical and mechanical responses. Therefore, in this study, physical, chemical, thermal, petrographic, and mechanical analyses were carried out to comprehend better the thermal behaviors of Egyptian granodiorite exposed to temperatures as high as 800 °C. The experimental results indicate that the examined attributes change in three distinct temperature phases. Strength zone (up to 200 °C): During this phase, the temperature only slightly impacts the granodiorite mass loss and porosity, and the P-wave velocity and E slightly decrease. However, the rock structure was densified, which resulted in a minor increase in strength. After that, the transition zone (200-400 °C) was distinguished by the stability of most studied parameters. For instance, mass and porosity did not significantly alter, and the uniaxial compressive strength steadily increased with an axial failure mode. When the temperature rises, transgranular cracks cause the P-wave velocity and elastic modulus to decrease moderately. The decay zone started after 400 °C and continued to 800 °C. This zone is characterized by complicated factors that worsen the granodiorite properties, lead to color shift, and produce a shear failure mode. The properties of granodiorite became worse because of chemical reactions, structural and crystal water evaporation, rising thermal expansion coefficient variation, and quartz inversion at 575 °C (α to β, according to the differential thermal analysis). Thermal damage greatly affected granodiorite's physical and mechanical properties and microstructure at 800 °C. As a result, UCS measurements were extremely small with a complex failure pattern, making Vp and E unattainable.