Biological behavior of human dental pulp cells on hydroxyapatite/tricalcium phosphate scaffold with different pore sizes

Peng Wei-wei,Zhai Wan-yin,Jiang Long,Li Li-fen,Chang Jiang,Zhu Ya-qin
DOI: https://doi.org/10.3969/j.issn.1673-8225.2010.51.015
2010-01-01
Abstract:BACKGROUND:Studies prove the feasibility of repairing dental defects using human dental pulp cells combined with hydroxyapatite/tricalcium phosphate (HA/TCP) scaffolds by means of tissue engineering methods.However,it is not clear that which pore size of scaffold can promote the growth and differentiation of dental pulp cells well.OBJECTIVE:To study the biological behaviors,such as adherence,proliferation and differentiation of human dental pulp cells on the HA/TCP scaffold with different pore sizes.METHODS:Human dental pulp cells were seeded into the HA/TCP scaffold with three kinds of pore sizes.Fluorescence microscope and scanning electronic microscope were used to observe the adherence and growth of cells to HA/TCP.Subsequently,the adherence and proliferation were assayed by adhesion rate and MTT tests,respectively.The complex of human dental pulp cells and HA/TCP scaffolds with different pore sizes were cultured with both growth medium and osteogenic medium,then the activity of alkaline phosphatase was determined at 4,7 and 10 days.RESULTS AND CONCLUSION:Human dental pulp cells adhered to the surface and the pores of HA/TCP scaffold successfully,and proliferated well.The highest rate of adhesion was observed in the group of the scaffold with pore size in the range of 100-300μm.Results of MTT showed that 300-500μm pore size group could promote cellular proliferation after 3 days.The alkaline phosphatase activity of human dental pulp cells,compound with the scaffolds with pore size of 100-300μm and 300-500μm,was significantly higher than 500-700μm group after 10 days incubation.The scaffold with the pore size in range of either 100-300μm or 300-500μm promoted the adhesion,proliferation and differentiation of human dental pulp cells better than the group of 500-700μm.
What problem does this paper attempt to address?