Abstract:Single-crystalline nanorods are intrinsic highways for charge transfer and hence ideal nanofeatures for efficient photoelectrochemical (PEC) degradations of pollutants in wastewater. Photocatalytic thin films on flexible substrates avoid the nuisance catalysts-recovering procedure and also allow for the flexible design in photo catalytic apparatus. We therefore directly deposited single-crystalline rutile TiO2 nanorod arrays on flexible and conductive Ti substrates through a hydrothermal technique and optimized the synthetic parameters to achieve an extremely high PEC activity towards phenol removal in water under UV light illumination. In the presence of tetrabutyltitanate (TBT) and HCl reactants under a hydrothermal environment, a balance in the erosion of the Ti substrate and the precipitation of TiO2 nanorods is found to be the key to tune the nanofeatures of the TiO2 thin films and in turn the PEC efficiency. The decreasing TBT concentration achieved a more sparsely distributed nanorod array, which significantly contributes to the PEC activity; yet too little TBT resulted in total dissolution of Ti plates. The PEC activity increased with increasing hydrothermal duration because of more loaded TiO2. The maximum reaction rate constant is 2.74 h(-1), which is 39 times that of a commercial P25 TiO2 nanoparticulate film. The photocurrent stabilized at 0.9 mA/cm(2) under the illumination of AM1.5G simulated solar light, suggesting a high separation efficiency of photogenerated holes and electrons along the single-crystalline rutile TiO2 nanorod arrays.

Single-crystalline TiO2 Nanorods: Highly Active and Easily Recycled Photocatalysts

Hydrothermal Growth of Nanorod Arrays and in Situ Conversion to Nanotube Arrays for Highly Efficient Ag-sensitized Photocatalyst

Preparation and Photocatalytic Activities of TiO2 Nanotubes with Mixed Crystal Structure

Highly Water-Dispersible and Easily Recyclable Anatase Nanoparticles for Photocatalysis

Nonaqueous sol–gel synthesis and growth mechanism of single crystalline TiO2 nanorods with high photocatalytic activity

Large-Scale Preparation Of Ordered Titania Nanorods With Enhanced Photocatalytic Activity

Synthesis Of Crystal-Controlled Tio2 Nanorods By A Hydrothermal Method: Rutile And Brookite As Highly Active Photocatalysts

Low Temperature Synthesis of Few-Layer Titanate Nanobelts on Ti Mesh and the Hot-Water Induced Transformations to Highly Photocatalytic Active Titania Nanorods

A facile synthesis of hierarchical TiO2 for dye adsorption and photocatalysis

Room‐Temperature Hydrolysis of Potassium Titanyl Oxalate and Water‐Assisted Crystallization for TiO2 with High Photocatalytic Activity

Single-crystalline Rutile TiO2 Nanorod Array on Flexible Ti Substrates for Efficient Photoelectrocatalytic Degradation of Phenol in Water

PHOTOCATALYTIC TETRACYCLINE DEGRADATION OVER TiO2 NANORODS

Self-assembly and Photocatalysis of Mesoporous TiO 2 Nanocrystal Clusters

Surface roughening and top opening of single crystalline TiO2 nanowires for enhanced photocatalytic activity

Low Temperature Synthesis and Photocatalytic Activity of Rutile TiO2 Nanorod Superstructures

Photocatalytic activity of TiO 2 nanorods, nanowires and nanoflowers filled with TiO 2 nanoparticles

One-pot Hydrothermal Synthesis of the Dual-Phase Anatase/tio2-B Nanoparticles with K2Ti6O13 Nanofibers for Enhanced Photocatalysis

Large-Scale Synthesis and Characterization of TiO2-Based Nanostructures on Ti Substrates

Low‐Temperature Transformation of Titania Thin Films from Amorphous Nanowires to Crystallized Nanoflowers for Heterogeneous Photocatalysis

Facile Synthesis of Ni-doped TiO2ultrathin Nanobelt Arrays with Enhanced Photocatalytic Performance

A Comparative Study on Photocatalytic Activity of Titania Nanowires Subjected to High-Temperature Calcination and Low-Temperature HCl Treatment