Abstract:Objective: To evaluate a new method for chest wall reconstruction using porcine-derived artificial rib and pleura in an animal experiment. Further, the clinical application was performed in five patients with large defects in the chest wall as a preliminary observation. Methods: In animal experiments, a full-thickness chest wall defect of 7 cm x 8 cm was created in 12 adult mongrel dogs. Six dogs underwent reconstruction with porcine-derived artificial ribs and pleura (test group), and six with methylmethacrylate and double polyester mesh in the form of traditional Marlex sandwich technique (control group). At follow-up of each for 3, 6, and 12 months postoperatively, a general performance assessment and thoracic radiography were performed. Gross and histopathological examinations were carried out following humane euthanasia at the time of last follow-up. In clinical application, five patients with wide tumor resection in the chest wall underwent reconstruction with porcine-derived artificial ribs and pleura as well. Results: In animal experiment, no perioperative death or hyperpyrexia occurred and no difference in either infection or dyspnea was noted between the two groups. Postoperative radiography revealed good thoracic integrity with no evidence of collapse, deformation, or abnormal movement in the test group. In the control group, similar results were observed, except that two dogs had abnormal movement in the chest wall associated with respiration. Severe adhesions between the 'sandwich' complex and the host tissues were identified in the control group, but by contrast, only mild adhesions were noted in the test group. The non-degradable polyester mesh induced fibrous proliferation and rejection, whereas the artificial pleura was absorbed with mild fibrous hyperplasia after 12 months. In clinical application, no thoracic deformity, chronic pain, or respiratory discomfort were observed at 1 or 12 postoperative months. Conclusions: Porcine-derived ribs and pleura can be employed safely to create an artificial chest wall to repair bony chest defects. The clinical results corresponded well with those of animal experiments, and thus confirmed the safety and feasibility of this new alternative of chest wall reconstruction. However, a long-term study in a large number is needed due to the small number of animals in this study. (C) 2011 European Association for Cardio-Thoracic Surgery. Published by Elsevier B. V. All rights reserved.

Frame construction of artificial chest wall with biomaterials:its design and evaluation

Experimental Reconstruction of Chest Wall Defects with Degradable Biomaterial in Dog

Chest wall reconstruction with polycaprolactone reinforced with degradable chitin short fiber in dogs

[Experimental Study of Degradable Chitin Long Fiber Reinforced Polycaprolactone for Reconstruction of Chest Wall Defects].

Experimental study of bio-material artificial chest wall for reconstruction of huge bony defects of chest wall in mongrels

Reconstruction of large chest wall defect with biomaterial artificial chest wall:Five cases report

A new alternative for bony chest wall reconstruction using biomaterial artificial rib and pleura: animal experiment and clinical application.

Preparation of a polydioxanone mesh as chest wall prosthesis

Functional Design and Biomechanical Evaluation of 3D Printing PEEK Flexible Implant for Chest Wall Reconstruction

Application of polydioxanone mesh in experimental chest wall reconstruction

[Research Status of the Skeletalre Construction of Chest Wall].

Functional Biomimetic Design of 3D Printed Polyether-ether-ketone Flexible Chest Wall Reconstruction Implants for Restoration of the Respiration

Primary Results of Chest Wall Reconstruction with Polydioxanone Mesh on Animals.

Bionic Design and Verification of 3D Printed PEEK Costal Cartilage Prosthesis.

Study on chest-wall reconstruction after chest-wall tumor resection

Finite element analysis and clinical study of chest wall reconstruction using carbon fiber artificial rib

Three-dimensional printing PEEK implant: a novel choice for the reconstruction of chest wall defect.

A facile strategy for fabricating composite patch scaffold by using porcine acellular dermal matrix and gelatin for the reconstruction of abdominal wall defects.

3D-printed biodegradable polycaprolactone rib implants with tissue-specific mechanical properties promote chest wall recovery by stimulating tissue fibrosis

Experimental Study of ASCs Combined with POC-PLA Patch for the Reconstruction of Full-Thickness Chest Wall Defects

Synthesis, structure, and properties of carbon/carbon composites artificial rib for chest wall reconstruction