Abstract:Optical fibre sensors (OFS) are worthy of interest for measurements in nuclear reactor thanks to their unique features, particularly compact size and remote multi-point sensing for some of them. But besides non negligible constraints associated with the high temperature environment of the experiments of interest, it is well known that the performances of OFS can be severely affected by high level of radiations. The Radiation Induced Attenuation (RIA) in the fibre is probably most known effect, which can be to some extent circumvented by using rad hard fibres to limit the dynamic loss. However, when the fast neutron fluence reaches 10 18 to 10 19 n/cm 2 , the density and index variations associated to structural changes may deteriorate drastically the performances of OFS even if they are based on rad hard fibres, by causing direct errors in the measurements of temperature and/or strain changes. The aim of the present study is to access the effect of nuclear radiations on the Fabry Perot (FP) and of Fibre Bragg Grating (FBG) sensors through the comparison of measurements made on these OFS - or part of them - before and after irradiation [1].In the context of development of OFS for high irradiation environment and especially for Material Testing Reactors (MTRs), Sake 2 experiment consists in an irradiation campaign at high level of gamma and neutron fluxes conducted on samples of fibre optics – bare or functionalised with FBG. The irradiation was performed at two levels of fast neutron fluence: 1 and 3.10 19 n/cm 2 (E>1MeV), at 250°± 25°C, in the SCK•CEN BR2 reactor (Mol Belgium). An irradiation capsule was designed to allow irradiation at the specified temperature without active control. The neutron fluence was measured with activation dosimeters and the results were compared with MCPN computations. Investigation of bare samples gives information on the density changes, while for the FBGs both density and refractive index perturbation are involved. Some results for bare fibres were reported recently. In this paper, we will focus on the measurements made on FBGs that have been manufactured by different laboratories on SMF 28 fibers: CEA, University of St-Etienne and University of Mons. Tested gratings have been written using various conditions (type of fibre, of laser, writing wavelength, power density, post writing thermal annealing,…), leading to various behaviours after Sake 2 irradiation. Bragg wavelength and reflectivity have been measured before and after irradiation thanks to a special mounting at the same temperature. It appears that a change in the shape after irradiation of the Bragg peak disturb the retrieval of the Bragg wavelength.The measurements show that for nearly all gratings the Bragg peak remains visible after the irradiation, and that Radiation Induced Bragg Wavelength Shifts (RI-BWSs) vary from few pm (equivalent to an error of less than 1°C for a temperature sensor) to nearly 1 nm (equivalent to 100°C) depending of the FBG types. High RI-BWSs could indeed be expected when considering the huge refractive index variation and compaction of the bare fibre samples that have been measured by other techniques. Post writing thermal annealing is confirmed as a key parameter in order to obtain a more radiation tolerant FBG. Our results show that specific annealing regimes allow making FGBs suitable to perform temperature measurements in a MTR experiment.

gamma-radiation damage of fiber Bragg grating and its effects on reflected spectrum characteristics

Effect of Kgy Dose Level Gamma Radiation on Ge-doped FBGs and Femtosecond-Laser-inscribed Pure-Silica-core FBGs

Effect of Temperature and Gamma-Ray Irradiation on Optical Characteristics of Fiber Bragg Grating Inscribed Radiation-Resistant Optical Fiber

Study of the Sensing Characteristics of Irradiated Fiber Bragg Gratings and Fabry-Perot Interferometers under Gamma Radiation

Experimental Investigation of Gamma Ray Radiation Effects on 1550nm Single Mode Fiber

Radiation Effects on Fiber Bragg Gratings: Vulnerability and Hardening Studies

Effect of Gamma Radiation on the Sensing Characteristics of FPs and FBGs

Influence of Pre-Radiation and Photo-Bleaching on the Yb-Doped Fiber Laser Radiated with Gamma-ray

Fiber Bragg Gratings of Type I in SMF-28 and B/Ge Fibre and Type IIA B/Ge Fibre under Gamma Radiation Up to 0.54 MGy

Fibre Bragg gratings as high dose radiation sensors?

Test of Fibre Bragg Gratings samples under High Fast Neutrons Fluence

Ionizing Radiation Effect upon Er/Yb Co-Doped Fibre Made by In-Situ Nano Solution Doping

Harmful Effects of Gamma Irradiation on Optical Fiber Communication System Links Under Thermal Environment Effects

Gamma Radiation-Induced Effects over an Optical Fiber Laser: Towards New Sensing Applications

Effect of Γ-Ray Irradiation on the Optical Property and Laser Damage Performance of Silica

Effect of Steady-state and Transient Γ Radiation on Ge-doped Quartz Optical Fiber

Comparative Investigation of Gamma Radiation Effects on Long Period Gratings and Optical Power in Different Optical Fibers

Effects of e-beam and gamma sterilization on attenuation of selected single-mode and mutimode optical fibers

Neutron versus Gamma Radiation Effects on Ytterbium-doped Optical Fibers

Analysis of Induced-Birefringence Effects on Fiber Bragg Gratings

Gamma Radiation Induced Darkening Effect on Ytterbium Doped Fiber Oscillators