Establishment and measurement of the scaphoid maximum length on spiral CT

GUO Yang,JIANG Bao-guo,TIAN Guang-lei,CHEN Shan-lin,TIAN Wen
2010-01-01
Abstract:Objective To measure the maximum length of scaphoid and the angle between the long axis and the proximal ulnar facet of scaphoid based on spiral CT scan, and also to investigate the difference of the angle and the length between the two sides as well as the two genders. Methods 30 cases of 3D CT reconstructions of bilateral normal scaphoids in a computerized operation planning and simulation system (Vxwork software) were obtained. The scaphoid maximum length, its proximal and distal points, and the angle (α) between the long axis and the proximal ulnar facet were obtained by software in this system. The differences of all the data obtained above between the two sides as well as the genders were evaluated. Results Average maximum length of 30 bilateral scaphoids generally was (28.05±2.12) mm. Scaphoid in male (29.31±1.55) mm was longer than it in female (26.6±1.83) mm , and there was no significant difference between the left and right scaphoids of the matched pairs. ∠α was (23.81±2.45)° in general, (23.25±2.40)° in male, (24.86±2.50)° in female. No difference was noted between the two sides and the genders. The position of the long axis was relatively stable, and the point on the distal pole was located in the central region of the tubercle and the point on the proximal pole was located in the middle 1/3 in the dorsal rim of the scaphoid proximal ulnar facet. The positions were symmetrical between the two sides. Conclusions The maximum length of scaphoid and the angle between the long axis and the proximal ulnar facet of scaphoid on spiral CT scan are relatively constant, and also there is no difference between the two sides, which showed normal contralateral scaphoid provided the best template for corrective surgery.
What problem does this paper attempt to address?