Abstract:The cavitation damage in the Engine cooling water pump (ECWP) is the key factor that shortens the lifespan of automobile cooling systems, and causes vibration and noise. To improve cavitation performance and external characteristics of ECWP, three optimized models were designed on the basis of WP7 diesel ECWP. The whole flow fields in three models and the prototype pump were numerically simulated, employing the time averaged Navier-Stokes equation, the standard k-ε turbulent model and Zwart-Gerber-Belamri multiphase flow model by ANSYS-CFX software. Pressure distribution, turbulent kinetic energy distribution, bubble volume fraction distribution, external characteristics and cavitation performance of the prototype pump and optimized models were compared and analyzed. The results show that the external characteristics and cavitation performance of the optimized models are significantly better than that in the prototype pump. Through decreasing the inlet blade angle and wrap angle, extending the blade to inlets and extending a certain inclination in the blade, shock loss in blade inlet was reduced and so, the performance of pump will be improved. The flow condition at blade inlet will also be improved greatly, which in turn improves cavitation performance. When reducing the quantity of blades, the excretion coefficient will drop, flow area of blade inlet becomes bigger, but head has a little drop. And the pump optimized by reducing the quantity of blades has the optimal cavitation performance among three optimized models. With the decrease of impeller diameter, the absolute pressure in the critical cavitation point becomes bigger, the inlet bubble volume fraction at the same absolute pressure increases while cavitation performance gets worse. The obtained numerical results were compared with the experimental ones, and the outcome showed the same tendency between the two along with acceptable error.

Numerical Simulation and Performance Prediction for Automotive Water Pumps

Performance Prediction of Centrifugal Pump Based on the Method of Numerical Simulation

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

Effect of Relative Positions between Blade and Volute Tongue on Prediction of Performance in Simulation of Centrifugal Pump

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Modelling and Experiment Study on Fluid Character of Axial Piston Pump

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

Model and Simulation on Flow and Pressure Characteristics of Axial Piston Pump for Seawater Desalination

Hydraulic performance prediction and optimization of an engine cooling water pump using computational fluid dynamic analysis

Numerical Simulation on Internal Flow in the Screw Centrifugal Pulp Pump

Numerical calculation and optimization designs in engine cooling water pump

Hydraulic Optimization and Loss Analyses of a Low Specific-Speed Centrifugal Pump with Variable-Thickness Blades

Research on multi-objective optimization of automotive electronic water pump motor considering the factor of gap viscous loss

Prediction Method of Impeller Performance and Analysis of Loss Mechanism for Mixed-Flow Pump

Modeling and Analysis of the Churning Losses Characteristics of Swash Plate Axial Piston Pump

Whole flow field performance prediction by impeller parameters of centrifugal pumps using support vector regression

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Modeling and experiment of the hydraulic losses of centrifugal pump with inlet guide vanes

Hybrid Analytical Model for Predicting the Electromagnetic Losses in Surface-Mounted Permanent-Magnet Motors

An Empirical Model for the Churning Losses Prediction of Fluid Flow Analysis in Axial Piston Pumps

Numerical and experimental study of variable speed automobile engine cooling water pump