Abstract:Multiple-input multi-output (MIMO), emerged as one of the most significant breakthroughs in wireless communications theory over the last two decades, is considered as a key to meeting the increasing demands for high data rates and mass wireless access services over a limited spectrum bandwidth. Transmit beamforming with receive combining is a low-complexity technique to exploit the benefits of MIMO wireless systems. It has received much interest over the last few years, because it provides substantial performance improvement without sophisticated signal processing. In order to enable the beamforming operation, either full or partial channel state information (CSI) has to be furnished to the transmitter. With full CSI, the optimal transmit beamforming scheme is maximum ratio transmission (MRT) [Dighe et al. (2003a)], where the principal right singular vector of the channel matrix is used as the beamforming vector. In Rayleigh fading, exact expressions for the symbol error rate (SER) of MRT were derived in [Dighe et al. (2003a;b)], and the asymptotic error performance was studied in [Zhou & Dai (2006)]. However, in certain application scenarios, e.g. frequency division duplex (FDD) systems, CSI is not usually available at the transmitter. To cope with the lack of CSI, a beamforming scheme based on finite-rate feedback has been proposed in the literature, where the CSI is quantized at the receiver and fed back to the transmitter. This scheme has been adopted in current 3GPP specifications. Under the assumption of independent block-fading and the assumption of delayand error-free feedback, the design and performance analysis of quantized beamforming systems have been well investigated. Different beamformer design methods were developed in [Mukkavilli et al. (2003); Love & Heath (2003); Xia & Giannakis (2006)]. In multiple-input single-output (MISO) cases, lower bounds to the outage probability and symbol error rate (SER) were derived in [Mukkavilli et al. (2003)] and [Zhou et al. (2005)], respectively. In MIMO cases, the average receive signal-to-noise ratio (SNR) and outage probability were studied in [Mondal & Heath (2006)]. Analytical results showed that full diversity order can be achieved by a well-designed beamformer [Love & Heath (2005)]. This chapter highlights recent advances in beamforming based on finite-rate feedback from a communication-theoretic perspective. We first study the SER performance when the feedback link is delayand error-free. Then non-ideal factors in the feedback link are investigated, and countermeasures are proposed to compensate the performance degradation due to non-ideal feedback. 12

Performance Analysis of Optimal Single Stream Beamforming in MIMO Dual-Hop AF Systems

Performance analysis of optimal beamforming in MIMO dual-hop amplify-and-forward systems

Two-Timescale Hybrid Analog-Digital Beamforming for Mmwave Full-Duplex MIMO Multiple-Relay Aided Systems

Performance Analysis and Beamforming Designs of MIMO AF Relaying with Hardware Impairments.

Performance Analysis of Optimal Joint Beamforming in Multi-Keyhole MIMO Channels

Optimum Beamforming for MIMO Multicasting

Optimal Cooperative Beamforming Design for Mimo Decode-And-Forward Relay Channels

0 Beamforming Based on Finite-Rate Feedback

A Unified Beamforming Structure for Wireless Multicasting and Power Transfer in MIMO Systems

Low Complexity and Near-Optimal Beam Selection for Millimeter Wave MIMO Systems.

Multiuser Opportunistic Beamforming Systems with Multiple Receive Antennas in Nakagami-$m$ Fading Channels

Joint Beam-Forming, User Clustering and Power Allocation for MIMO-NOMA Systems

Dynamic Hybrid Beamforming With Low-Resolution PSs for Wideband mmWave MIMO-OFDM Systems

Outage Analysis for Optimal Beamforming Mimo Systems in Multikeyhole Channels

Capacity and Performance Analysis of Advanced Multiple Antenna Communication Systems

A Robust Beamforming Algorithm for Multiple Access Systems with Multiple-Input Multiple-Output and Single-Carrier Frequency Division

Transmit beamforming for MIMO multicast channels

Dynamic MIMO Architecture Design for Near-Field Communications

Multi-user Beamforming-Aided AF Relaying: A Low-Complexity Adaptive Design Approach.

Analog-Only Beamforming for Near-Field Multiuser MIMO Communications

Performance Analysis of Interference-Limited Dual-Hop Multiple Antenna AF Relaying Systems with Feedback Delay