Abstract:The circumferentially non-uniform clearance has significant effect on the overall performance and operation safety of high loading compressor rotors. However, both the variation rules and mechanism of flow characteristic in the circumferential, radial and streamwise directions caused by the asymmetric clearance are not fully clarified, which restricts the performance degradation assessment and rubust design of high loading compressors. Therefore, different types of asymmetric tip clearance were designed in this paper to reveal the circumferential fluctuation laws and induced mechanism of key characteristic parameters in full-channel domains of compressor rotor with circumferentially non-uniform clearance. It is shown that the circumferentially non-uniform clearance has less effect on the total pressure ratio and efficiency of compressor rotor, while it causes an obvious deterioration of the stall margin. Furthermore, the circumferentially non-uniform clearance causes the circumferential fluctuations of performance parameters, and the fluctuation amplitude has been affected by the eccentricity ratio and operating condition of rotor directly. In addition, the leakage flow originated from a single channel may pass through about three adjacent channels in rotor with uniform clearance, while it covers almost seven adjacent channels in the rotor with circumferentially non-uniform clearance. In consequence, it is precisely the difference of strength variation of leakage flow in tip region caused by the circumferential distributions of tip clearance that produces an alternated variation of low-velocity zone in rotor prototype and a concentrated distribution of low-velocity zone in the range of 270° to 360° of rotor with non-uniform clearance. Due to the serious blockage appearing in this range, the rotating stall of transonic rotor with circumferentially non-uniform clearance has occurred in advance, even with a maximum drop of 35.94% in stall margin.

Experimental Study of Effects of One Kind of Tangentially Non-Uniform Tip Clearance on the Flow Field at an Exit of A Compressor Cascade Passage

Vortex structure control based bleed in axial compressor cascade with tip clearance using large eddy simulation

Numerical investigation on the influence of nonuniform tip clearance on rotor tip-clearance flow field structure

Effect of moving end wall on tip leakage flow in a compressor cascade with different clearance heights

Effects of tip clearance on flow field and performance of a centrifugal compressor

Numerical Study of Porous Tip Treatment in Suppressing Tip Clearance Vortices in Cavitating Flow

Effects of Circumferentially Non-Uniform Clearance on the Spanwise Flow Characteristics in a Transonic Compressor Rotor

Effect of Tip Clearance on Compressor Performance

Experimental and numerical investigations of tip clearance flow and loss in a variable geometry turbine cascade

Effect of Nonuniform Tip Clearance on the Performance of Transonic Axial Compressors

Flow quality improvement of the wind tunnel testing for a highly-loaded compressor cascade at high incidence

Experimental and Numerical Investigations for Dual−Cavity Tip Aerodynamic Performance in the Linear Turbine Cascade

Effect of Leakage Flow on the Endwall Cooling Performance in High Subsonic Turbine Cascade

Numerical Study of Two Types of Rough Groove in Suppressing the Tip Clearance Cavitation

Effects of moving endwall on the unsteadiness of tip leakage flow in compressor cascades

Numerical Simulation of Effect of Blade End Slot on Performance of Compressor Cascade

Numerical Study of Tip Leakage Vortex Around a NACA0009 Hydrofoil

Experimental Investigation of Aerodynamic Performance due to Blade Tip Clearance in a Gas Turbine Rotor Cascade

Research on the effect of centrifugal compressor blade tip clearance distribution on conbustion engine turbocharger performance

Interaction mechanism between the tip leakage flow and inlet boundary layer in a highly loaded compressor cascade based on scale-adaptive simulation

Study on the Tip Leakage Loss Mechanism of a Compressor Cascade Using the Enhanced Delay Detached Eddy Simulation Method