Comparative Study of Si-Ti Thin Films and Alloys As Lithium Ion Anodes
Yukun Wang,Hui Liu,Min Zhu,Mark N Obrovac
DOI: https://doi.org/10.1149/ma2016-02/3/283
2016-01-01
ECS Meeting Abstracts
Abstract:Si based materials have been intensively studied due to the high theoretical capacity of Si (2194 Ah/L, 3579 mAh/g [1, 2]) and applicable lithiation voltage (around 0.4 V [3]). To address the issues brought by severe volume change during the charge-discharge process, the concept of active-inactive Si based alloys has been developed. Si can form intermetallic compounds with some inactive (towards Li) metals, such as Fe, Co, Mn and Ni [4]. These inactive Si1-xMx phases dilute the expansion of Si and thereby improve electrode cycling performance. Recent reports suggested that the voltage curves of Si1-xMxalloys can be shifted by hundreds of millivolts, presumably due to the stress induced by the volume expansion of active Si while being bonded to the inactive phase [5]. In this work, Si1-xTix (0 ≤ x ≤ 0.4, Δx = 0.05) alloys were prepared both by ball milling and magnetron sputtering. The structure evolution of these alloys and their electrochemical performance as negative electrodes for lithium ion batteries were compared. The capacity dependence of the Si-Ti alloys on Ti content suggests that these alloys comprise an active Si phase and an inactive Si phase. A voltage shift was observed during the lithiation process of Si1-xTix thin-films. Increasing the Ti content (x ≤ 0.3) was found to gradually lower the lithiation voltage by a shift of up to 600 millivolts, while the average voltage during delithiation process remains constant. (Figure 1). The voltage shift during discharge suppresses the formation of the Li15Si4phase at full lithiation, resulting in improved cycling performance. This presentation will discuss the structural and electrochemical characteristics of sputtered and ball-milled Si-Ti alloys and their relation to alloy reversible capacity and cycle life. Acknowledgements The authors acknowledge funding from NSERC and 3M Canada, Co. under the auspices of the Industrial Research Chair and Discovery grant programs. We also acknowledge the support of the Canada Foundation for Innovation, the Atlantic Innovation Fund and other partners that fund the Facilities for Materials Characterization managed by the Institute for Research in Materials. Yukun Wang acknowledges the support from SCUT Doctoral Student Short-term Overseas Visiting Study Funding Project. References [1] M.N. Obrovac and L. Christensen, Electrochem. Solid-State Lett., 7 (5) A93, (2004). [2] M.N. Obrovac and L.J. Krause, J. Electrochem. Soc., 154(2) A103, (2007). [3] L. Baggetto, R.A.H. Niessen, F. Roozeboom, and P.H.L. Notten, Adv. Funct. Mater., 18(7) 1057 (2008). [4] Z. Du, T.D. Hatchard, R.A. Dunlap and M.N. Obrovac, J. Electrochem. Soc., 162 (9) A1858, (2015). [5] Z. Du, S.N. Ellis, R.A. Dunlap and M.N. Obrovac, J. Electrochem. Soc., 163 (2) A13, (2016). Figure 1