Abstract:A novel quasi-optical coherence vibration tomography (Quasi-OCVT) measurement system suitable for structural damage detection is proposed by taking the concept of two-dimensional optical coherence vibration tomography (2D-OCVT) technique. An artificial quasi-interferogram fringe pattern (QIFP) similar to the interferogram of 2D-OCVT system, as a sensor, was pasted on the surface of a vibrating structure. Image sequences of QIFP were captured by a high-speed camera that worked as a detector. The period density of the imaged QIFP changed due to the structural vibration, from which the vibration information of the structure could be obtained. Noise influence on the measurement accuracy, torsional sensitivity and optical distortion effect of the Quasi-OCVT system were investigated. The efficiency and reliability of the proposed method were demonstrated by applying the system to damage detection of a cracked beam-like structure with a roving auxiliary mass. The roving of the mass along the cracked beam brings about the change of natural frequencies that could be obtained by the Quasi-OCVT technique. Therefore, frequency-shift curves can be achieved and these curves provide additional spatial information for structural damage detection. Same cases were also analyzed by the finite element method (FEM) and conventional accelerometer-based measurement method. Comparisons were carried out among these results. Results obtained by the proposed Quasi-OCVT method had a good agreement with the ones obtained by FEM, from which the damage could be directly detected. However, the results obtained by conventional accelerometer showed misleading ambiguous peaks at damage position owing to the mass effect on the structure, where the damage location cannot be identified confidently without further confirmation. The good performance of the cost-effective Quasi-OCVT method makes it attractive for vibration measurement and damage detection of beam -like structures. (C) 2017 Elsevier Ltd. All rights reserved.

Optical Coherence Tomography-based Structural Vibration Sensor System

Real-Time Monitoring of Structural Vibration Using Spectral-Domain Optical Coherence Tomography

Two-Dimensional Optical Coherence Tomography for Real-Time Structural Dynamical Characterization

Two-dimensional optical coherence vibration tomography for low-frequency vibration measurement and response-only modal analysis

Enhanced optical coherence tomography for vibration and thermal deformation measurement based on spectrum correction technique

Acoustic-Excitation Optical Coherence Vibrometer for Real-Time Microstructure Vibration Measurement and Modal Analysis

Vision-based measurement system for structural vibration monitoring using non-projection quasi-interferogram fringe density enhanced by spectrum correction method

Vibration Measurement of Smart Composite Structures by Using the New Intensity Modulated Optical Fiber Sensor

A Coatable, Light-Weight, Fast-Response Nanocomposite Sensor for Thein Situacquisition of Dynamic Elastic Disturbance: from Structural Vibration to Ultrasonic Waves

Modulated Pulses Based Distributed Vibration Sensing with High Frequency Response and Spatial Resolution.

Quasi-OCVT Technique for Response-Only Experimental Modal Analysis of Beam-Like Structures

Through- Hole Cantilever Beam Vibration Sensor Based on Dispersion-Turning-Point Optical Microfiber Coupler

A New Optical Sensing Device for Real-Time Noncontact Vibration Measurement Considering Light Field Variation

Distributed Vibration Sensor Based on Coherent Detection of Phase-OTDR

Long-range Vibration Sensor Based on Correlation Analysis of Optical Frequency-Domain Reflectometry Signals.

Quasi-optical Coherence Vibration Tomography Technique for Damage Detection in Beam-Like Structures Based on Auxiliary Mass Induced Frequency Shift

Distributed Vibration Sensing with Time-Resolved Optical Frequency-Domain Reflectometry.

Distributed Temperature/Vibration Fiber Optic Sensor With High Precision and Wide Bandwidth

Optical Heterodyne Microvibration Detection Based on All-Fiber Acousto-Optic Superlattice Modulation

Atomic Vibration Sensor

Vibration Monitoring with High Frequency Response Based on Coherent Phase-Sensitive OTDR Method