Study on the Processes of Separating and Purifying Ω-Cyanoundecanoic Acid

LI Lin,WU Ming,XU Wei-jian
DOI: https://doi.org/10.3321/j.issn:1003-9015.2007.01.029
2007-01-01
Abstract:Taken the purity and recovery rate as object, three different self-designed separating and purifying processes used to obtain ω-cyanoundecanoic acid (11-CUA) from the oil and water mixture produced from the 1,1’-peroxydicyclohexylamine (PXA) pyrolysis were compared, and the most suitable one of them was chosen. The selected process consists of several steps as follows. Firstly, ammonifying the oily mixture of PXA pyrolysis by ammonia or aqueous ammonia, then adding the organic solvent to extract the impurities in the ammonified mixture secondly, acidifying the water layer of the ammonified mixture containing cyanoundecanoate by sulfuric or hydrochloric acid to obtain the crude 11-CUA thirdly, and finally, crystallizing it in suitable medium to yield high purity 11-CUA crystals. The technological parameters of the selected process were optimized by single factor experiments and orthogonal tests respectively. The results show that the optimized parameters of the process are as follows. The pH value and temperature used for ammonifying are 8.0~10.0 and 25~35℃ respectively, toluene is chosen as extraction solvent, the pH and temperature used for acidifying are 1.5~2.0 and 55~60℃ respectively, cyclohexane is selected as crystallization medium and the crude 11-CUA is dissolved at 50~55℃, initial mass ratio of crude 11-CUA to cyclohexane is 4 : 100, demixion time of cyclohexane solution of 11-CUA before crystallizing is 10 minutes and crystallization temperature is 20 ℃. Using above mentioned selected process and the optimized process parameters, the 11-CUA product purity and recovery rate can reach 99.90% and 90.22%, respectively.
What problem does this paper attempt to address?