Abstract:The use of a two-step thermal-oxidative analysis (TOA) technique for quantification of the mass of total carbon (TC) and elemental carbon (EC) of turbine engine-borne particulate matter (PM) has been evaluated. This approach could be used in lieu of analysis methods which were developed to characterize diluted PM. This effort is of particular interest as turbine engine PM emissions typically have a higher EC content than ambient aerosols, and filter sample mass loadings can be significantly greater than recommended for existing analysis techniques. Analyses were performed under a pure oxygen environment using a two-step temperature profile; reference carbon and actual PM samples were used to identify appropriate analysis conditions. Thermal gravimetric analysis (TGA) methods were used to provide guidance on the nature of the carbon in several of the materials. This was necessary as a standard reference material does not exist for determination of the EC fraction in PM. The TGA also assisted in identifying an appropriate temperature range for the first-stage of the TOA method. Quantification of TC and EC for turbine engine PM samples using TOA was compared to results obtained using the NIOSH 5040 thermal-optical method. For first-stage TOA temperatures of 350°C and 400°C, excellent agreement between the techniques was observed in both the quantified TC and EC, supporting the viability for using TOA for analysis of turbine engine PM samples. A primary benefit of using TOA for these types of PM samples is that filters with relatively high PM mass loadings (sampled at the emission source) can be readily analyzed. In addition, an entire filter sample can be evaluated, as compared to the use of a filter punch sample for the NIOSH technique. While the feasibility of using a TOA method for engine PM samples has been demonstrated, future studies to estimate potential OC charring and oxidation of EC-type material may provide additional data to assess its impact on the OC/EC fractions for other carbon-type measurements. Implications: This work presents results and procedures of an analytical method for the determination of total and elemental carbon, i.e., TC and EC present in combustion source particulate matter samples. In general, it is shown that the LECO TOA methodology is as reliable and comprehensive as NIOSH 5040 for determining TC and EC carbon types in particulate matter present in turbine emission sources, and should be considered as an alternative. Principles of the methodology, differences, and corresponding agreement with the standard NIOSH 5040 method and TGA analysis are discussed.

Effects of temperature parameters on thermal-optical analysis of organic and elemental carbon in aerosol

Optimization of temperature protocol for carbonaceous aerosol thermal-optical analysis using the TLLP approach

Intercomparison of thermal-optical methods for the determination of organic and elemental carbon: influences of aerosol composition and implications.

Improved Measurement of Carbonaceous Aerosol: Evaluation of the Sampling Artifacts and Inter-Comparison of the Thermal-Optical Analysis Methods

Measurement of Carbonaceous Aerosol with Different Sampling Configurations and Frequencies

Characterization of two aerosol carbon analyzers based on temperature programmed oxidation: TCA08 and FATCAT

Ambient Organic Carbon to Elemental Carbon Ratios: Influence of the Thermal–optical Temperature Protocol and Implications

Intercomparison of thermal-optical method with different temperature protocols: Implications from source samples and solvent extraction

The Effects of Accumulated Refractory Particles and the Peak Inert Mode Temperature on Semi-Continuous Organic Carbon and Elemental Carbon Measurements During the CAREBeijing 2006 Campaign

Harmonizing Aerosol Carbon Measurements Between Two Conventional Thermal/optical Analysis Methods.

Characterization of carbonaceous aerosol by the stepwise-extraction thermal-optical-transmittance (SE-TOT) method

Quantification of elemental and total carbon in combustion particulate matter using thermal-oxidative analysis

Effects of Sterilization Treatments on the Analysis of TOC in Water Samples.

Quantifying the uncertainties in thermal-optical analysis of carbonaceous aircraft engine emissions: An interlaboratory study

Positive sampling artifact of carbonaceous aerosols and its influence on the thermal-optical split of OC/EC

The Impact of Ammonium on the Distillation of Organic Carbon in PM2.5

Temperature effects on optical properties and chemical composition of secondary organic aerosol derived from <i>n</i>-dodecane

Uncertainties in Thermal-Optical Measurements of Black Carbon: Insights from Source and Ambient Samples.

An automated method for thermal-optical separation of aerosol organic/elemental carbon for 13C analysis at the sub-μgC level: A comprehensive assessment

Characteristics of Temporal Variations in Organic and Elemental Carbon Aerosols from Eastern China in 2011–2020

Ambient organic carbon to elemental carbon ratios: Influences of the measurement methods and implications