Treatment of Fuel-Oil Contaminated Soils by Biodegradable Surfactant Washing Followed by Fenton-Like Oxidation

T. T. Tsai,C. M. Kao,Rao Y. Surampalli,S. H. Liang

DOI: https://doi.org/10.1061/(asce)ee.1943-7870.0000052

IF: 2.479

2009-01-01

Journal of Environmental Engineering

Abstract:Among petroleum-hydrocarbon pollutants, fuel-oil is more difficult to treat compared to gasoline and diesel fuel. The objectives of this bench-scale study were to: (1) develop a two-stage remedial system consisting of surfactant washing followed by Fenton-like oxidation process to remediate fuel-oil contaminated soils; (2) evaluate the effects of residual surfactant and soil organic matter (SOM) on the efficiency of Fenton-like oxidation; (3) evaluate the effect of potassium dihydrogen phosphate (KH2PO4) addition on the stability of H2O2 and oxidation efficiency; and (4) evaluate the possible oxidation products after the oxidation process. In the surfactant washing stage, biodegradable surfactant, Simple Green (SG) (50 g L-1), was applied to flush fuel-oil contaminated soils with initial total petroleum-hydrocarbons (TPHs) concentration of 50,000 mg kg(-1). Results show that approximately 90% of TPH could be removed after washing with 45 pore volumes (PVs) of SG followed by 25 PVs of deionized water, while the soil TPH concentration dropped from 50,000 to 4,950 mg kg(-1). In the Fenton-like oxidation stage with initial soil TPH concentration was approximately 4,950 mg kg(-1), TPH removal efficiency can be significantly increased with increased H2O2 concentrations. Results also reveal that residual SG and SOM would compete with TPH for oxidants and cause the decrease in oxidation efficiency. An "oxidation-sorption-desorption-oxidation" scheme for soil TPH was observed in this experiment due to the initial sorption of TPH on SOM. Results show that an addition of 2.2 mM of KH2PO4 could increase the stability and half-life of H2O2, but caused the decrease in TPH removal efficiency. The oxidation potential of Fenton-like process was not capable of completely oxidizing fuel-oil to nontoxic end products. The observed by-products after oxidation process contained carboxyl groups with molecular weights similar to their parent compounds. Results from this study indicate that the two-stage remedial system is a promising technology for fuel-oil contaminated soil treatment.