FFT-Based Simultaneous Calculations of Very Long Signal Multi-Resolution Spectra for Ultra-Wideband Digital Radio Frequency Receiver and Other Digital Sensor Applications
Chen Wu,Michael Low
DOI: https://doi.org/10.3390/s24041207
IF: 3.9
2024-02-14
Sensors
Abstract:The discrete Fourier transform (DFT) is the most commonly used signal processing method in modern digital sensor design for signal study and analysis. It is often implemented in hardware, such as a field programmable gate array (FPGA), using the fast Fourier transform (FFT) algorithm. The frequency resolution (i.e., frequency bin size) is determined by the number of time samples used in the DFT, when the digital sensor's bandwidth is fixed. One can vary the sensitivity of a radio frequency receiver by changing the number of time samples used in the DFT. As the number of samples increases, the frequency bin width decreases, and the digital receiver sensitivity increases. In some applications, it is useful to compute an ensemble of FFT lengths; e.g., 2P−j for j=0, 1, 2, ..., J, where j is defined as the spectrum level with frequency resolution 2j·Δf. Here Δf is the frequency resolution at j=0. However, calculating all of these spectra one by one using the conventional FFT method would be prohibitively time-consuming, even on a modern FPGA. This is especially true for large values of P; e.g., P≥20. The goal of this communication is to introduce a new method that can produce multi-resolution spectrum lines corresponding to sample lengths 2P−j for all J+1 levels, concurrently, while one long 2P-length FFT is being calculated. That is, the lower resolution spectra are generated naturally as by-products during the computation of the 2P-length FFT, so there is no need to perform additional calculations in order to obtain them.
engineering, electrical & electronic,chemistry, analytical,instruments & instrumentation