Abstract:We studied several wetting boundary conditions (WBCs) in the simulation of binary fluids based on phase-field theory. Five WBCs, three belonging to the surface energy (SE) formulation using the linear, cubic and sine functions (denoted as LinSE, CubSE and SinSE), the fourth using a geometric formulation (Geom), and the fifth using a characteristic interpolation (CI), were compared with each other through the study of several problems: (1) the static contact angle of a drop; (2) a Poiseuille flow-driven liquid column; (3) a wettability gradient (WG)-driven liquid column; (4) drop dewetting. It was found that while all WBCs can predict the static contact angle fairly accurately, they may affect the simulation outcomes of dynamic problems differently, depending on the driving mechanism. For the flow-driven problem, to use different WBCs had almost no effect on the flow characteristics over a large scale. But for other capillarity-driven problems, the WBC had some noticeable effects. For the WG-driven liquid column, Geom gave the most consistent prediction between the drop velocity and dynamic contact angles, and LinSE delivered the poorest prediction in this aspect. Except for Geom, the dynamic contact angle differed from the prescribed (static) one when other WBCs were used. For drop dewetting, Geom led to the most violent drop motion whereas CubSE caused the weakest motion; the initial contact line velocity was also found to be dependent on the WBC. For several problems, CubSE and SinSE gave almost the same results, and those by Geom and CI were close as well, possibly due to similar consideration in their design. Besides various comparisons, a new implementation that may be used for all WBCs was proposed to mimic the wall energy relaxation and control the degree of slip. This new procedure made it possible to allow the simulations to match experimental measurements well.

Simulation of interfacial tension based on the method of solubility parameter

Simulation of surface tension force using moving particle semi-implicit method

Studies on Liquid–liquid Interfacial Tension with Standard Dissipative Particle Dynamics Method

Simulation of Vapor-Liquid Coexistence Using Dissipative Particle Dynamics

Simulation of Surface-Tension-driven Interfacial Flow with Smoothed Particle Hydrodynamics Method

Simulations of Interfacial Tension of Liquid-Liquid Ternary Mixtures Using Optimized Parametrization for Coarse-Grained Models

Improvement of Surface Tension Model and Numerical Investigation on Droplet Wetting Effect

Dissipative particle dynamics simulation of interface tension in the ternary triton X-100/toluene/H2O system

Fast Simulation of Immiscible Liquids Interaction

Droplet Deformation and Surface Tension Modeling Using the Smoothed Particle Hydrodynamics Method

Simulation of Multiphase Micro-Drop Dynamics Using Dissipative Particle Dynamics

Numerical Investigation on Droplet Wetting Effect With the MPS Method

Surface Tension Model Based on Implicit Incompressible Smoothed Particle Hydrodynamics for Fluid Simulation

Investigations of Interfacial Properties of Surfactants with Different Structures at the Oil/Water Interface Using Dissipative Particle Dynamics

The establishment of IB-SEM numerical method and verification of fluid-solid interaction

Numerical Simulation for Incompressible Gas-Liquid Two-Phase Interfacial Flows with Immersed Solid Boundaries

A Novel Interface Method for Two-Dimensional Multiphase SPH: Interface Detection and Surface Tension Formulation

Simulating the Rheology of Suspensions Using Dissipative Particle Dynamics

Wetting Boundary Conditions in Numerical Simulation of Binary Fluids by Using Phase-Field Method: Some Comparative Studies and New Development

Thermodynamic Study of Interfacial Tension Between Fluids (Non-Surfactant Systems)

A Molecular Thermodynamic Model for Interfacial Tension in Surfactant-Oil-Water System