Abstract:The planetary mill is one of the most commonly used mills for ultrafine grinding in the laboratory, given its ability to reach higher intensity of the collisions as the result of increase in rotational frequency and ball acceleration without the undesired centrifugation of the grinding charge. Several attempts have been made in the literature to develop a predictive model of this mill, with limited success. The work applies the mechanistic UFRJ mill modeling approach to predict the size distribution in a laboratory planetary mill, on the basis of single-particle slow compression data obtained using a micro compression tester, besides simulations using the discrete element method. At first, careful verification of the Hertz-Mindlin contact parameters was conducted using a video recording system that moves along with the jar during milling. Grinding tests were conducted with hematite for the mill operating at frequencies that varied from 150 to 300 rpm, resulting in generally very good agreement between model and experiments. However, agreement between the two was found to reduce for the highest rotational frequency studied. This was attributed to the reduction in grinding efficiency in the experiments that was not observed in the simulations, which resulted in predicted values overestimating fineness of the product. Finally, simulations were compared to experiments for quartz, silicon carbide and blast furnace slag under identical conditions and it was shown that the model provided very good predictions, with the exception of quartz.

Simulation of the Milling Process Using a Vertical Roller Mill

Numerical Investigation of a Vertical Roller Mill Using DEM-MBD Coupling Method

Modeling and Control Optimization in Cement Vertical Roller Mill Process

Meshless Modeling of the Breakage Process of a Coal Prism within Vertical Roller Mills

Mechanistic modeling and simulation of a wet planetary ball mill

Multiscale Digital Twin for Particle Breakage in Milling: from Nanoindentation to Population Balance Model

3D Simulation Study of Milling Process Based on LS-DYNA

Ball Mill Grinding Process Simulation Based on Population Balance Model

A combined experimental and DEM approach to determine the breakage of particles in an impact mill

Multi-level DEM Study on Liner Wear in Tumbling Mills for an Engineering Level Approach

Dynamic Modeling of Ball Mills

Particle Size Distribution Predictive Model of Industrial Ball Mill Based on Batch Grinding Experiment

Numerical Simulation of Milling Process: A Total Procedure

Analysis of vertical roller mill performance with changes in material properties and operating conditions using DEM

A DEM Based Scale-Up Model for Tumbling Ball Mills

Simulation of Grinding Process for Cemented Carbide Based on an Integrated Process-Machine Model

Milling Process Simulation for the Variable Pitch Cutter Based on an Integrated Process-Machine Model

Simulation Method of the Micro-Geometrical Texture of Milling Surfaces

Numerical Identification Of Roll Compression Induced Disintegration Modes Of A Coal Prism Within Roller Mill

Study For Simulation Analysis And Experiment On High-Speed Dry Gear Milling By Flying Cutter

A Forward Closed-Loop Virtual Simulation System for Milling Process Considering Dynamics Processing-Machine Interactions