Effect of Additives on the Stability of Emulsified Diesel Collector

LIU Teng-fei,FENG Li

DOI: https://doi.org/10.3969/j.issn.1006-7167.2012.12.006

2012-01-01

Abstract:For the purposes of improving the stability of emulsified diesel collector,the 0# diesel oil in the market was taken as a dispersed phase,the tap water as the continuous phase,and the mechanical agitation as the approach of emulsification,the effect of the emulsifier,the co-emulsifier and stabilizing agent on the emulsion stability was studied.The results showed the optimum chemical formula as follows: the hydrophile-lipophile balance value was 14,the quantity ratio of the sorbitan monooleate,the polyoxyethylene sorbitan monooleate and sodium lauryl sulfate were 20∶13∶7 respectively to mixed emulsifier,the dosage of mixed emulsifier was 1.5%(quantity fraction),the dosage of co-emulsifier which was n-butyl alcohol was 5%(quantity fraction),and dosage of stabilizing agent polyethylene glycol was 0.5%(quantity fraction).The Grain-size of emulsion's disperse phase is approximately 5 to 6 μm equally and of uniform distribution.The stabilization time surpasses 20 d and shows good thermal stability.At the same time,the result shows that compared to 0# diesel oil,the clean coal rate was same in the end of floatation,the economizing rate of petrol is above 70%,and the ash content of clean coal is 0.74% lower than diesel oil based on the preliminary floatation experiment.