Abstract:This paper describes a mechanical model of the mid‐ocean ridge axis based on a nonlinear rheology. The oceanic lithosphere is modeled as a strongly temperature‐dependent “power law” material with the Byerlee's friction law describing the brittle behavior of the upper oceanic lithosphere. We examined two simple models. A mantle‐only model predicted an axial rift valley 1–2 km deep and 10–15 km wide at slow half‐rates of 5–25 mm/yr which is in fair agreement with observations. However, the rift valley did not completely vanish at fast spreading rates even though its width and relief became much smaller. Thus, the mantle‐only model failed to explain the observed transition in axial topography with spreading rate. By including a uniform thickness oceanic crust with theological properties different from the mantle, our second model produced the first order variation of axial topography with spreading rate: a pronounced rift valley with 1–2 km relief at slow rates, a smaller relief (<500 m) rift valley at intermediate rates, and no rift valley at fast rates. There are two additional results of the nonlinear rheology model which are distinctively different from the previous uniform viscosity mantle models. First, horizontal velocity at the seafloor changes sharply in a very narrow zone at the ridge axis, i.e., the stresses are concentrated in a very narrow zone for the nonlinear rheology. This conclusion is remarkably independent of the boundary conditions at the seafloor. Second, the computed width of the axial plastic failure zone decreases with spreading rate, a result very different from that of a uniform viscosity model. This is caused by the strong temperature dependence of the power law rheology and the fact that the temperature of the oceanic lithosphere depends greatly on the spreading rate. Beyond some distance from the ridge axis, the brittle plate (roughly the region above the 750°C isotherm) deforms very little; both the horizontal strain rate ė11 and the maximum shear strain rate ėmax are less than 10−17 s−1 which is in good agreement with the 10−18 s−1 average for oceanic brittle plate deformation inferred from seismic moment data. Within the ductile region (area beneath the 750°C isotherm) the strain rates are in the range of 10−14–10−16 s−1, except within a narrow band near the ridge axis where higher strain rates are located. We found that the thermal structure of the oceanic lithosphere is not very sensitive to the details of the mantle flow pattern (or the rheology) but is very sensitive to the cooling by hydrothermal circulation near the ridge axis. Axial structure is also influenced by factors other than the spreading rate. Within the range of slow and intermediate rates, our calculations show that the size of an axial rift valley decreases with an increase in either the thickness of the oceanic crust or the mantle temperature; in other words, a thinner crust or a cooler mantle temperature will produce a more pronounced rift valley. In the vicinity of hotspots, the absence of an axial rift valley even at slow spreading rates, such as the Reykjanes Ridge, can be well explained by the anomalously thicker crust and higher mantle temperatures. In contrast, at the Australian‐Antarctic Discordance a deeper than normal section of an intermediate spreading ridge has very rough topography not present on the adjacent sections of the ridge; this can be explained by our model as due to an anomalously low mantle temperature as has been suggested or perhaps also due to a thinner oceanic crust

Mechanisms for the Formation of Ridge-Axis Topography Atslow-Spreading Ridges: a Lithospheric-Plate Flexural Model

Magmato-tectonic Mechanism of Southwest Indian Ridge (49°-50°E) Inferred from Quantitative Morphotectonic Analysis Based on High-Resolution Multibeam Bathymetry

Ridge Offsets, Normal Faulting, and Gravity Anomalies of Slow Spreading Ridges

Rift Valley/no Rift Valley Transition at Mid‐ocean Ridges

A Nonlinear Rheology Model for Mid‐ocean Ridge Axis Topography

Tectonic Modification of Axial Crustal Structure: Evidence from Spectral Analyses of Residual Gravity and Bathymetry of the Mid-Atlantic Ridge Flanks

Models of Ocean Ridge Lithospheric Deformation: Dependence on Crustal Thickness, Spreading Rate, and Segmentation

The crustal nature of the northern Mozambique Ridge, Southwest Indian Ocean

Precollisional Tectonics and Terrain Amalgamation Offshore Southern Taiwan: Characterizations from Reflection Seismic and Potential Field Data

The Reykjanes Ridge, North Atlantic

Highly variable magmatic accretion at the ultraslow-spreading Gakkel Ridge

Crustal Thickness and Structure along Three Contrasting Spreading Segments of the Mid‐Atlantic Ridge, 33.5°–35°N

Crustal Evolution over the Last 2 M.y. at the Mid‐Atlantic Ridge OH‐1 Segment, 35°N

Mechanism of Structure Variations at Rifted Margins in the Central Segment of South Atlantic: Insights from Numerical Modeling

Evidence of an Axial Magma Chamber Beneath the Ultraslow-Spreading Southwest Indian Ridge

Segmentation in Gravity and Magnetic Anomalies along the Us East Coast Passive Margin: Implications for Incipient Structure of the Oceanic Lithosphere

Paleomagnetic constraints on plate tectonic process at south mid-Atlantic ridge

Morphotectonic Evolution of Passive Margins Undergoing Active Surface Processes: Large‐Scale Experiments Using Numerical Models

Crustal and Upper Mantle Seismic Structure Beneath the Rift Mountains and Across a Nontransform Offset at the Mid‐Atlantic Ridge (35°N)

Crustal Thickness of V‐shaped Ridges South of the Azores: Interaction of the Mid‐Atlantic Ridge (36°–39°N) and the Azores Hot Spot

Trans‐Lithospheric Ascent Processes of the Deep‐Rooted Magma Plumbing System Underneath the Ultraslow‐Spreading SW Indian Ridge