Comparison of the Early Developmental Ability Between in Vivo and in Vitro Produced Mouse Parthenogenetic Embryos Induced by Electrical Activation
Jing-wei LIU,He-juan LI,Yan-yun YIN,Li-ping CHEN,Xiao-yan LI,Yun-hai LIU,He-min NI,Yong GUO,Lin LU
DOI: https://doi.org/10.3969/j.issn.1005-4847.2011.06.007
2011-01-01
Abstract:Objective This study was aimed to investigate the early developmental ability between in vivo or in vitro produced mouse parthenogenetic embryos induced by electrical activation.Methods Using different electric pulse parameters and activation solutions to activate the mouse oocytes and to observe the in vitro developmental ability of these embryos and their evolving post-transplantation capacity.Results The non-electrolyte solution was superior to the electrolyte solution.Each parameter of their pulse intensity,pulse width and pulse frequency was suitable within a certain range.There were some compensated correlations among them: If a parameter was reduced,its reduction could be compensated by the other two parameters immediately.Therefore,the screened appropriate electrical pulse parameters were as following: 1.0 kV/cm,40 μs,2 p,or 1.5 kV/cm,30 μs,2 p.The activation rates were 74.65% and 71.19%,respectively,as well their in vitro blastocyst rates were 43.4% and 47.62%,respectively.In addition,the electrical activation sequence of those in vitro produced parthenogenetic embryos,seemed to be slower than that of normal ones,but the blastocyst cell number was not significantly different to that of the control group.The implantation rate of the parthenogenetic embryos was significantly lower than that of the control one(3.6% vs.67%,P0.05).Conclusions The electrical stimulation can almost mimic the normal fertilization process of murine oocytes,but most of these parthenogenetic embryos can not successfully initiate the implantation.