Abstract:The paper is concerned about a measuring method developed by the present author based on FTIR for measuring the concentrations of components in the toxic gases harmful both to human health and the environment quality.The said experimental system was established based on the use of Fourier transform infrared spectrometer, gas compounding equipment,vacuum pump as well as other devices. To make the quantitative analysis successful,we have chosen eight kinds of classic toxic gases with low concentration,including CO, CO_2,NO,NO_2,SO_2,HCl,HBr and HCN.The best calculated spectrum regions of the 8 components were analyzed in hoping to avoid the interference of vapor and carbon dioxide from the outside environment as the result of a series of trials and appropriate choice. The sample of calibration set has been tested and verified by the method of Mahalanobis distance (M) for the model to be soundly established. For example,we have deleted two samples due to their being less purposeful for our research goals.Then,two data matrixes were adopted to establish our model,one of which is infrared spectrum data matrix and the other of which is the gas concentration data matrix.And,finally,the partial least square (PLS) regression model was established after choice of an appropriate spectrum region,data pre-treating,standards selection and parameters setting.With the result of each component verified by the P1.S model and regulated by the multinomial,the fitting regression coefficient between the actual concentrations and predicted concentrations of each component proved to be higher than 0.99,and the Root-mean Standard F.rror of Calibration (S_(RMSEC)) proves lower than 15 × 10~(-6).With the expected performance of the model well verified by the standards in validation set,the error of the concentration prediction proves lower than ±2% FS and the Root-mean Standard Error of Prediction (S_(RMSEP)) is lower than 20 × 10~(-6).Thus,it can be seen that the proposed qualitative analysis of such toxic gases based on FTIR is a new valuable method for gas detection,which can be applied for environmental monitoring, chemical plants' quality-inspection,fire-hazards detection,anti-terrorist activities and other areas concerned.

Design of software system for mid-infrared Fourier transform multi-component gas analyzer

Design for Multi-Gases Analyzer Based on FTIR Principle

Design and Realization of a Multi-Spectra Based Portable Water Quality Analyzer

Development of A Multi-Spectra Based Portable Water Quality Analyzer

The Design Of A New Integrated Gas Sensor Array Based On Fea

Research and Design of Signal Processing and Control System of Infrared Gas Analyzer Based on Internet of Things Technology

Design of Portable Quantitative Detectors for Methane Based on MSP430

Design of 2 Gas Automobile Emission Gas Analyzer System

Development and Application of Multi-Component Dynamic Gas Distribution Instrument Based on Mass Flow Controller

Standoff Gas Identification and Application with Ftir Imaging Spectrometer

Development and application of domestic on-line Fourier infrared gas analyzer

Design of an FT-NIR Spectrometer for Online Quality Analysis of Traditional Chinese Medicine Manufacturing Process

Rapid Identification of Atmospheric Gaseous Pollutants Using Fourier-Transform Infrared Spectroscopy Combined with Independent Component Analysis

Study on the Multi-Channel Scanning Fiber-Optic Infrared Spectrum System for Measuring Gas Concentration

Study on the Quantitative Analysis of Multi-Component Toxic Gases Based on FTIR

Study on System for Extracted Type Infrared Gas Analysis

Design of multi-component gas measurement system based on STM32

Dual-Interference Channels Static Fourier Transform Imaging Spectrometer Based on Stepped Micro-Mirror: Data Processing and Experiment Research

The application of frequency and amplitude response spectroscopy analyzing

CH4, C2H6, and CO2 Multi-Gas Sensing Based on Portable Mid-Infrared Spectroscopy and PCA-BP Algorithm