Effect of water on the electrical conductivity of lower crustal clinopyroxene

Xiaozhi Yang,Hans Keppler,Catherine McCammon,Huaiwei Ni,Qunke Xia,Qicheng Fan
DOI: https://doi.org/10.1029/2010JB008010
2011-01-01
Abstract:The electrical conductivity of lower crustal clinopyroxene was measured at 6-12 kbar, 250-1000 degrees C, and Ni-NiO buffer conditions. The dependence of electrical conductivity on water content was studied using both natural and preannealed samples separated from a fresh xenolith granulite, with water contents from 0 to 375 ppm. An end-loaded piston cylinder apparatus and a Solarton-1260 Impedance/Gain Phase Analyzer were used in the study over a frequency range of 0.01-10(6) Hz to obtain the complex impedance spectra. The results show that the influence of pressure is very weak relative to temperature and water content and that two distinct mechanisms with different activation enthalpies dominate electrical conduction under dry and wet conditions. For the dry sample, the activation enthalpy is similar to 102 kJ/mol and the main charge carriers are small polarons, i.e., hopping of electron holes between ferrous and ferric irons. For wet samples, the electrical conductivity is significantly enhanced with an activation enthalpy of similar to 70 kJ/mol and the charge carriers are likely to be protons. Under hydrous conditions, the activation enthalpies are nearly independent of water content and the conductivity is a function of water content with an exponent of similar to 1. As a major constituent of granulites with > 60% modal volume in some regions, clinopyroxene containing minor amounts of water may contribute significantly to the high electrical conductivity in the lower crust, especially under stable continental regions.
What problem does this paper attempt to address?