Abstract:This paper presents a C-X band frequency sweeping source with wide bandwidth, high frequency resolution, fast frequency hopping and low phase noise. In order to achieve a frequency hopping time within 10ns, ADI’s DDS IC AD9914 is adopted due to its high frequency reference clock. Meanwhile, it is capable of delivering an RF signal with a frequency higher than 1GHz, which is beneficial to minimize the frequency multiplication factor of the followed frequency multiplying chain. A comb spectrum generator circuit with a step recovery diode (SRD) is designed to produce a reference signal of 3400MHz for the DDS. By configuring DDS internal registers, a triangular wave frequency modulation signal with adjustable period and sweeping frequency is realized. An 8-time frequency multiplying chain is designed to extend the output frequency of DDS to 6GHz to 9GHz. To improve the flatness of the output power within 6GHz to 9GHz, an amplitude equalizing circuit is optimized utilizing lumped components. The measured results demonstrate that the frequency sweeping system has a power flatness better than ±1.1dB and a spurious suppression better than 40dBc in the range of 6GHz to 9GHz. The measured phase noise is generally better than -117dBc/Hz at 100KHz offset.

Design of broadband frequency-sweep signal generator based on FPGA and AD9854

Design of a low-cost broadband sweep generator

Design of a Fast-Sweeping C-X Band Frequency Source Based on DDS and Frequency Multiplying Chain

Design of DDS Signal Source Based on DSP Builder

Design of Wideband Step Frequency Signal Source Based on FPGA

Design of FM Signal Generator Based on DDS Technique and Implementation with FPGA

A Multifunction Signal Generator Based on DDS and Its Implementation on FPGA

Study on Arbitrary Waveform Generator for Radar Based on DDS

Direct Digital Frequency Synthesizer Design Based on FPGA

Design and Implementation of Direct Digital Frequency Synthesis Sine Wave Generator Based on FPGA

FPGA and DDS-based Function-signal-generator Design

Design of Intelligent Signal Generator Board Based on FPGA

Design of DDS+PLL Frequency Hopping Signal Source Based on FPGA

Note: A High-Frequency Signal Generator Based on Direct Digital Synthesizer and Field-Programmable Gate Array.

Design of a Sine Signal Generator

Design of the FPGA control circuit of the DDS frequency agile signal generator

Design of C-band wideband sweep frequency source

Design of a Polyphase Parallel DDS Waveform Generator

Design and Experiments of a Waveform Generator Based on DDS Technology

Structural Design of a Parallel DDS Based on FPGA

Design of typical waveform generator based on DDS/SOPC