Abstract:Upon free solidification of a deeply undercooled melt, the solute diffusion in both the interface and the bulk liquid is far from equilibrium, and the concentration and the fluid flow may also play an important role in the solidification. Thus, under such conditions, assumptions about local equilibrium, ideal dilute solution solidification and solidification free of fluid flow can no longer be valid. In the present work, first, in order to reveal the concentration effect, we compared the results of the non-equilibrium dendrite growth models describing the solidification of dilute and non-dilute undercooled melts. It was found that under local non-equilibrium conditions, the predicted results of the non-dilute solution model and the dilute solution model are to a certain extent different from each other at the intermediate undercooling range. It was also found that the concentration effect could substantially decrease the relaxation effect. Second, we considered the effect of fluid flow on the rapid solidification of an undercooled melt. It was found that the fluid flow would affect not only the size of the dendrite tip radius, mainly at the small undercooling range, but also the dendrite growth velocity at the intermediate undercooling range. In particular, fluid flow makes the sizes of the dendrite tip radius at high undercooling close to those predicted by the dilute model. Thus, fluid flow could make the non-dilute solution exhibit dilute solution solidification behaviors. It was also found that fluid flow reduces the relaxation effect to some extent. Considering the fluid flow effect, we used an extended chemical superheating model to predict the dendrite remelting phenomenon of the non-dilute melt. The model predicted that the dendrite remelting phenomenon would abruptly disappear once the dendrite growth velocity exceeded the solute diffusion velocity in a bulk undercooled melt. Third, considering the fluid flow effect, we used the concept of equivalent undercooling and a recently developed physical model to calculate the stress accumulation during rapid solidification. The results of this new model could explain well the stress-induced dendrite breakup mechanism of grain refinement at high undercooling.

The Effect of the Shear Flow on Directional Solidification of Scn-3wt% Salol Alloy

Morphological determination of forced shear flow rate during directional solidification of succinonitrile-1%salol alloy

The Mechanism of Directional Cellular Growth with Shear Flow

Directional Growth of Monotectic Alloy with and Without Shear Flow

The effect of shear flow on the dendritic characteristics

Periodical Oscillating Interface in Directional Growth under Shear Flow

Effect of Directional Solidification Methods on Solid Solution Window in Ni-based Single-Crystal Superalloy

The Effect of Shear Flow on the Formation of L 2 Droplet During Directional Monotectic Solidification

Phase-Field Modeling of Solute Trapping in Single-Phase Alloys During Directional Solidification

Directional Dendrite Growth of SCN-3wt% H 2 O under Shear Flow

The Interactive Dynamics of Flow and Directional Solidification in A Hele-Shaw Cell Part 1. Experimental Investigation of Parallel Shear Flow

Numerical Simulation of Effect of Pulling Velocity on Structure Evolution During Directional Solidification of Ti-45Al Alloy

A Time-Dependent Interface Stability During Directional Solidification of a Single Phase Alloy(ⅱ)comparison with Experimental Results

Ultrasonic Cavitation and Acoustic Streaming Effects During Liquid Phase Separation and Dynamic Solidification of Ternary Al–Sn–Si Immiscible Alloy

Concentration and Fluid Flow Effects on Kinetics, Dendrite Remelting and Stress Accumulation Upon Rapid Solidification of Deeply Undercooled Alloys

Intermittent nucleation and periodic growth of grains under thermo-solutal convection during directional solidification of Al-Cu alloy

Study on the Solutal Convection During Dendrite Growth of Superalloy under Directional Solidification Condition

In situ analysis of solute and flow fields in directional solidification of immiscible Al–Bi alloy

The Effect of the Shear Flow on Columnar Crystal Growth in an Undercooled Melt

Effects of Crystal Orientation and Pulling Rate on the Liquid-Solid Interface Morphology in the Directional Solidification of DD8 Nikel Base Superalloy

Microstructure Evolution During Directional Solidification of 2009al/sicp at Different Pulling Velocities: Modeling and Experiment