Preparation and Performance of Ito/Fe(3+)-Tio(2)/Ito Solid-State Planar Photoelectrocatalytic Devices

Shang Jing,Xue Lian,Li Jia,Zhao Fengwei
DOI: https://doi.org/10.3321/j.issn:0253-9837.2008.10.017
IF: 16.5
2008-01-01
Chinese Journal of Catalysis
Abstract:A Fe3+-TiO2 film was fabricated on the ITO(indium tin oxide)substrate to make solid planar photoelectrocatalytic devices ITO/Fe3+-TiO2/ITO.The photoelectrocatalytic performance of the ITO/Fe3+-TiO2/ITO device under air and nitrogen conditions was tested using gaseous formaldehyde degradation as the model reaction.The device current was measured using a Keithley 2400 SourceMeter instrument.The results showed that the existence of HCHO increased the photocurrent of the photoelectrocatalytic system.Furthermore,the photocurrent under nitrogen was higher than that under air.This indicated that HCHO participated in the transfer of electrons.The photocatalytic activity of the ITO/Fe3+-TiO2/ITO device was higher than that of ITO/TiO2/ITO,which suggested that Fe3+ had entered the crystal lattice of TiO2.The photocurrent of ITO/Fe3+-TiO2/ITO was less than that of ITO/TiO2/ITO,indicating that the decrease in the rate of electron transfer resulting from the Fe3+ doping was much higher than the improvement of the dissociation efficiency of photogenerated excitons.Although the photocatalytic activity of ITO/Fe3+-TiO2/ITO was enhanced under bias,this activity increase was less obvious than that of ITO/TiO2/ITO.
What problem does this paper attempt to address?