Abstract:A novel coaxial mixer was proposed, which had an outer wall-scraping frame and a combined inner impeller consisting of a four-pitched-blade turbine paddle (PBT-4) and a Rushton turbine paddle (RT-6). Its heat transfer performance in Newtonian fluid under different operating modes (single rotation of inner impeller, corotation and counter-rotation) was experimentally investigated in a stainless steel agitated vessel with semicircle spiral jacket and ellipsoidal head by measuring the average heat transfer coefficient of the inner wall. Meanwhile, the wall temperature, the heat flow rate and the local heat transfer coefficient in the coaxial agitated vessel were determined with the help of numerical simulation. The results show that the heat transfer coefficient near the inner wall surface of the agitated vessel will increase with the increasing speed of the inner or outer impeller whether under single-shaft agitation or under coaxial agitation mode, whereas the effect of speed of the inner impeller on heat transfer is more obvious and efficient. Under the same conditions, the heat transfer of coaxial agitation is more efficient than that of single-shaft agitation, especially the local heat transfer coefficient on the upper and lower part of the agitated vessel, which is increased greatly. In addition, the local heat transfer coefficient varies with the axial position of the agitated vessel, and the heat transfer coefficient in zones between the upper and lower impeller is relatively high. The effect of the corotation mode and counter-rotation mode on heat transfer is of little difference, but the corotation mode is recommended owing to its advantage of low power consumption and good mixing performance.

Power consumption of inner–outer helical ribbon impellers in viscous Newtonian and non-Newtonian fluids

Numerical Investigation of Hydrodynamics and Heat Transfer for Bingham-pseudoplastic Fluids in an Industrial Coiled Stirred Tank

Experimental Research on the Power Consumption of a Coaxial Mixer in a Fluid with High Viscosity

RESEARCH ON THE FLUID-INDUCED EXCITATION CHARACTERISTICS OF THE CENTRIFUGAL PUMP CONSIDERING THE COMPOUND WHIRL EFFECT

Power Consumption and Flow Field Characteristics of a Coaxial Mixer with a Double Inner Impeller

A Novel Investigation of a Micropolar Fluid Characterized by Nonlinear Constitutive Diffusion Model in Boundary Layer Flow and Heat Transfer.

A New Investigation of Power Consumption and Metzner Constant for Anchor Impellers

Numerical Simulation of Power Consumption and Mixing Characteristic in Stirred Vessel with Novel Coaxial Mixer

Numerical Simulation of Hydrodynamics and Mixing Characteristics of High-Viscosity Non-Newtonian Fluid in Twin-Shaft Kneaders

Numerical Simulation of Power Consumption and Mixing Characteristics of Novel Large-Double-blade Impeller

Research on Heat Transfer Performance of Coaxial Mixer with Inner Combined Impeller

A New Correlation for Slip Factor in Radial and Mixed-Flow Impellers

Mixing performance of a non-Newtonian fluid in a coaxial agitated impeller reactor

Power Consumption of Horizontal Two-Shaft T-Shape Self-C leaning Agitator in Newtonian Fluid

Simulation Analysis of Power Consumption and Mixing Time of Pseudoplastic Non-Newtonian Fluids with a Propeller Agitator

Numerical Investigation and Estimating Correlation of Micromixing Performance of Coaxial Mixers

Numerical investigation of hydrodynamic performance and power consumption in stirred reactors with perforated Scaba 6SRGT impellers for non‐Newtonian fluid

Energy efficiency analysis for high-viscosity fluid mixing enhanced by flexible impeller

Analysis of Power Input of an In-Line Rotor-Stator Mixer for Viscoplastic Fluids

Numerical investigation of internal flow characteristics in a mixed-flow pump with eccentric impeller

Impact of non-Newtonian fluid behavior on hydrodynamics and mass transfer in spacer-filled channels