Abstract:Equal channel angular expansion extrusion with spherical cavity (ECAEE-SC) was introduced as a novel severe plastic deformation (SPD) technique, which is capable of imposing large plastic strain and intrinsic back-pressure on the processed billet. The plastic deformation behaviors of commercially pure aluminum during ECAEE-SC process were investigated using finite element analysis DEFORM-3D simulation software. The material flow, the load history, the distribution of effective strain and mean stress in the billet were analyzed in comparison with conventional equal channel angular extrusion (ECAE) process. In addition, single-pass ECAEE-SC was experimentally conducted on commercially pure aluminum at room temperature for validation, and the evolution of microstructure and microhardness of as-processed material was discussed. It was shown that during the process, the material is in the ideal hydrostatic stress state and the load requirement for ECAEE-SC is much more than that for ECAE. After a single-pass ECAEE-SC, an average strain of 3.51 was accumulated in the billet with homogeneous distribution. Moreover, the microstructure was significantly refined and composed of equiaxed ultrafine grains with sub-micron size. Considerable improvement in the average microhardness of aluminum was also found, which was homogenized and increased from HV 36.61 to HV 70.20, denoting 91.75% improvement compared with that of the as-cast billet.

Microstructure and Dry Sliding Wear Behavior of Cu–10%Al–4%Fe Alloy Produced by Equal Channel Angular Extrusion

Tensile Deformation Behaviors of CuNi Alloy Processed by Equal Channel Angular Pressing

Dry Sliding Wear Behavior of Tini Alloy Processed by Equal Channel Angular Extrusion

Tribological and mechanical behavior of AL 2014 aluminum alloy influenced by microstructure and texture evolution after equal channel angular processing

Microstructural evolution of Al-Mg-Er-Zr alloy by equal channel angular extrusion at room temperature

Mechanical Properties and Microstructure of AZ31 Mg Alloy Processed by Two-Step Equal Channel Angular Extrusion

Microstructure Evolution of AZ31 Mg Alloy During Equal Channel Angular Extrusion

Tribological behavior of an AlCoCrFeNi2.1 eutectic high entropy alloy sliding against different counterfaces

Effect of equal channel angular extrusion process on deformation behaviors of Mg-3Al-Zn alloy

Microstructure Evolution and Cooperative Strengthening Mechanism of Copper–Aluminum Bimetal Continuous Equal Channel Angular Pressing-Annealing Process

Structural Characterization of Binary Al-Cu Alloy Processed by Equal Channel Angular Pressing at Half of the Melting Point

Effect of extrusion-ECA integrated large strain technology on microstructure and properties of 7075 aluminum alloy

Microstructure Evolution and Mechanical Properties of AZ80 Mg Alloy during Annular Channel Angular Extrusion Process and Heat Treatment

Influence of Equal Channel Angular Pressing and Cyclic Extrusion Compression on the Microstructure Evolution and Mechanical Properties of Pure Aluminum

Effects of annular channel angular extrusion process and heat treatment on microstructure and mechanical properties of 2A12 aluminum alloy cabin

Ebsp Investigation of Microstructure and Texture Evolution During Equal Channel Angular Pressing of Aluminium

Evaluation of the Structural Characteristics and Wear Performance of the Novel ECAR-Processed AA5083 Alloy

Evolution of Microstructure and Mechanical Properties of Al-Zn-Mg-Cu Alloy by Extrusion and Heat Treatment

Impact of Equal Channel Angular Pressing on Mechanical Behavior and Corrosion Resistance of Hot-Rolled Ti-2Fe-0.1B Alloy

Severe plastic deformation of commercially pure aluminum using novel equal channel angular expansion extrusion with spherical cavity

Investigations on the microstructures and tribological behaviors of as-cast CrFeCoNiCu x high entropy alloys