Abstract:Kinetics of thermal degradation of plasticized poly(vinyl chloride) (PVC) containing acid scavenger, epoxidized linseed oil (ELO), was investigated. ELO presence allowed to separate direct hydrochloric acid (HCl) elimination and HCl induced autocatalytic degradation regions, to obtain distinct rate constants and activation energies of both processes as a function of PVC glass transition temperature. Diffusivities of HCl in PVC were computed, showing that PVC degradation kinetics was not controlled by the rate of HCl diffusion. Kinetic compensation effect was established. Kinetics of non‐oxidative thermal degradation of poly(vinyl chloride) (PVC) plasticized with di(2‐ethylhexyl)phthalate and epoxidized linseed oil (ELO) were studied using differential scanning calorimetry. PVC thermal degradation autocatalyzed by forming HCl is delayed in the presence of acid scavenging ELO. Direct HCl elimination rates during steady state degradation (induction period) were almost independent on ELO concentration, with rate constants ranging from ≈3.2×10−6 s−1 at 463 K to ≈7.0×10−5 s−1 at 503 K. Activation energy of HCl elimination increased with glass transition temperature (Tg) increase from 136.0 kJ mol−1 at Tg=260.3 K to 141.9 kJ mol−1at Tg=274.2 K. Diffusion coefficients of HCl diffusion in plasticized PVC deduced using Williams‐Landel‐Ferry equation were of the order of 10−4 cm2 sec−1. Calculated activation energy of HCl diffusion in plasticized PVC was ≈30 kJ mol−1. The rate constants of PVC autocatalytic degradation were derived from the experimental data (for the 1st time) using Šesták‐Berggren approach and ranged from 3.2×10−2 sec−1 at 503 K to 4.4×10−3 sec−1 at 463 K. Autocatalysis activation energies ranged from 70.4 kJ mol−1 to 85.1 kJ mol−1 and increased with increase of glass transition temperature. It was established that PVC degradation kinetics was not controlled by HCl diffusion. Compensation effect was observed for initial and catalyzed PVC degradation.

Thermal Degradation Kinetics of Poly (vinyl Chloride)

Effects of Crystallization Temperature of Poly(vinylidene Fluoride) on Crystal Modification and Phase Transition of Poly(butylene Adipate) in Their Blends: a Novel Approach for Polymorphic Control.

Thermal degradation of typical plastics under high heating rate conditions by TG-FTIR: Pyrolysis behaviors and kinetic analysis

Kinetic Study of PVC Pyrolysis in Air by Thermogravimetric Analysis Using the Friedman Method

Study on Thermal Reactions of PP/PVC Composites

TG-FTIR analysis of PVC thermal degradation and HCl removal

Study on Kinetics of Pyrolysis of PVC

Kinetic study of mechanical and thermal properties and thermal degradation of PVC composites based on coal gasification fine slag

Terahertz dielectric spectroscopy based thermal‐oxidative aging analysis of polyvinyl chloride

Kinetics of Plasticized Poly(vinyl chloride) Thermal Degradation, Induction, Autocatalysis, Glass Transition, Diffusion

Thermal degradation of polymers. I. Aspects of polytetrafluoroethylene degradation

The Crystallinity of Pvc and Its Effect on Physical Properties

Thermal Behavior of Poly(vinyl alcohol) in the Form of Physically Crosslinked Film

Kinetics of thermal oxidative degradation of poly (vinyl chloride) containing Ca and Sn at low temperature

Thermal degradation and optical characteristics of plasticized poly(vinyl chloride-co-vinyl acetate-co-2-hydroxypropyl acrylate) terpolymer

Dual nature of noncatalytic hydrothermal dechlorination kinetics of PVCs: Insights from thermal dehydrochlorination

Studies of thermal decomposition of poly(vinyl chloride) composition with cadmium yellow and stearic acid

Atomic insights into the thermal degradation of polyethylene terephthalate combining STA-FTIR and DFT methods

Thermal properties and degradation of polytetrafluoroethylene low‐molecular fractions

Thermal decomposition kinetics of poly(vinyl chloride) insulation for overloaded and non-overloaded wires

Thermal characterization of polylactides