Abstract:In this paper, signal descriptions and formulations for the radio frequency ( RF) front-end of a passive backscatter radio frequency identification ( RFID) reader working at ultra high frequencies ( UHF) are discussed in detail, and a set of design considerations aiming to improve the read range are outlined. The reader's architecture is proposed and the design details of its RF frond-end are presented. The read range is formulated through calculating the time-averaging power absorbed by the tag and the signal-noise-ratio ( SNR) of the demodulation, and accordingly RFID systems can be classified into tag-determining and reader-determining ones. It is concluded that the gain of the reader antenna, the phase noise of the local oscillation ( LO) and the receive-transmit isolation coefficient dominate the demodulation output noise of the reader, and consequently the reader-determining maximum operational distance. A prototype reader working at the frequency of 915MHz was built with off-the-shelf components and was evaluated with a commercial tag in an indoor environment. The measured results show that this RFID system is of tag-determining and has a read range of 8.4 meters, which are in good agreement with the calculated results.

Design and Implementation of a UHF Active RFID System

Design for the reader of UHF Radio frequency identification

Design and Application of Active Radio Frequency Identification System

A System Design for the Reader of Microwave Radio Frequency Identification

Design of Active Microwave Radio Frequency Identification System and Its Communication Module

Design and implantation of high frequency radio frequency identification reader virtual instrumentation system

Design and implementation of a long-range RFID reader

Signal Descriptions and Formulations for Long Range Uhf Rfid Readers

Development of a Low-cost Active RFID Platform

The Design of the RF Front-End of Reader Based on SAW RFID

Design of a Base Band Module for RFID System Based on DSP

Design and Optimization of a CDMA-Based Multi-Reader Passive UHF RFID System for Dense Scenarios

Design and Implementation of Portable Reader System Based on UHF RFID

Design of RFID active tag system based on MSP430

Design of an UHF RFID Interrogator

Secure Uhf-Rfid Tag for Vehicular Traffic Management System

The Hardware Design and Implementation of Four-Channel UHF RFID Reader Based on Impinj R2000

The Design of a General HF RFID Reader

A Robust Radio Frequency Identification System Enhanced with Spread Spectrum Technique.

Design and Realization of A Uhf Rfid Interrogator

Design And Implementation Of A Rf Transceiver Front-End For Uhf Rfid Localization System