Abstract:According to the Maxwell-Wagner model, there is much amount of space charge at the interface between two different insulations. The more difference of ratios between dielectric constant and conductivity of both insulations, the higher amount of space charge emerges at the interface. And the higher amount of space charge stores at the interface, the more distortion of electrical field occurs. Therefore it is one of most important factors to considering the compatibility of dielectric constant and conductivity of cable and accessory insulations in polymer insulated HVDC power cable. There are many ways to evaluate the compatibility, such as calculating the ratios of dielectric constant and conductivity in both insulations at various temperatures. However, most of the ways are indirect and it is very difficult to satisfy the engineers designing cable accessory insulation. In the paper, composite samples of silicon and/ or ethylene-propylene-diene (EPDM) rubbers with LE4253 were prepared, respectively. Space charge at the interface between rubber and LE4253 were measured with pulse-acoustic method at various temperatures. It is found that character of space charge at the interface is the same in both composite samples. However, the amplitude of space charge at the interface between SIR/LE4253 is much greater than that at the interface between EPDM/LE4253 and it goes upwards quickly as the temperature arises. At the same time space charge at the interfaces in both composite samples moves distinctly towards both electrodes. In addition, the character of space charge in both kinds of rubbers varies at different vulcanizing temperatures. At last it is indicated that not only the space charge suppression of accessory insulation, but also the space charge at the interface in the composite sample should be considered as designing cable accessory.

Formation of Space Charges at Interface Between Ethylene Propylene Diene Terpolymer and Silicone Rubber

Space Charge Characteristics of Cross-linked Polyethylene and Silicone Rubber Interface under Different Tensile Rate

Investigation of space charge at the interface between the insulation of cable and its accessory

Formation Mechanism of Space Charge Accumulation at SR and XLPE Interface under Temperature Gradient

Space Charge Accumulation in Silicone Rubber Influenced by Poole-Frenkel Effect

Effect of Surface Fluorination on Space Charge Behavior at LDPE/EPDM Interface

The Effect Of Temperature Gradient On Space Charge Accumulation At Sr/Xlpe Interface Under Dc Stress

Space Charge Formation in Silicone Rubber

Effect of Silicone Grease Coating on Space Charge Characteristics of XLPE / SIR Interface

Research on Property Variation of Silicone Rubber and EPDM Rubber under Interfacial Multi-Stresses

Formation Mechanism Of Space Charge In Silicone Rubber Insulation Under Low Dc Stress

Study on Space Charge Accumulation in Silicone Rubber Encapsulant under DC Voltage

Space Charge Characteristics at the Interface of Laminated Epoxy Resin

The Effect of Nano TiO2 on Space Charge Behaviour of Silicone Elastomer under DC Electric Field

Effect of Space Charge on Electric Field Distribution at the Insulating Interface Between DC Cable and Accessory

Study on Influence of Space Charge on Hydrophobicity of Silicone Rubber

Continuous Positive Space Charge in Silicone Rubber Insulation

Effects of Interface Pressure and Surface Roughness on the Partial Discharge between Polyethylene and Silicone rubber

Formation and Inhibition Mechanisms of Space Charges in Direct Current Polyethylene Insulation Explained by Energy Band Theory

Study on space charge accumulation characteristics of silicone elastomer under DC voltage

Study on Conduction Current and Space Charge Accumulation Simultaneously in Ethylene Propylene Diene Monomer Film