Abstract:We present here line of sight communication between a person and his neighbour with the help of optical signal produced by a laser torch which act as a carrier. It is therefore a wireless communication and the transmission can go up to 500 meters. We used photodiode to receive the signal at the receiver. The transmitter circuit comprises condenser microphone transistor amplifier BC547 followed by an op-amp stage built around μA741. When we give a voice signal from the mike, it converts the voice signal into the electrical signal. This electrical signal is fed to IC741 (op-amp) for amplification. The gain of the op-amp can be controlled with the help of 1-mega-ohm potentiometer. The AF output from IC is coupled to the base of a class B amplifier which, in turn, modulates the signal. The transmitter uses 5V power supply. However, the 3-volt laser torch (after removal of its battery) can be directly connected to the circuit-with the body of the torch connected to the class B. The photodiode converts the optical signal into electrical signal and again this signal is amplified using IC741 and a combination of class B push pull amplifiers. The receiver circuit uses an NPN photodiode as the light sensor that is followed by a two-stage transistor preamplifier and IC741 based audio Power amplifier. The receiver does not need any complicated alignment. Just keep the photodiode oriented towards the remote transmitter’s laser point and adjust the volume control for a clear sound. The sensor must not directly face the sun.

Based on infrared communication circuit design and production

An Inductorless Transimpedance Amplifier Design for 10 Gb/s Optical Communication Using 0.18-Μm CMOS

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

A Compact 2-18Ghz Ultra-Wideband Frequency-conversion T/R Module Based on a 3D Heterogeneous Integrated Process

Infrared ray test instrument's design and realization

Research on Key Technology of Long-Distance-coefficient Infrared Thermoscope

Application of Infrared Communication in Intelligent Time Relay

A High-Gain CMOS Common-Gate Preamplifier for IrDA

Analysis and Design of a High Performance Infrared Detector Readout Circuit

The Infrared Remote Technology In Embeded System

Handheld Laser Rangefinder and Its Transmitter Circuit

Indoor Infrared Wireless Communication System Based on Ethernet Network

An Infrared Communication System based on Handstand Pendulum

A Low Cost And High Performance Design Of X-Band Short Range Doppler Radar Transceiver

DC Photocurrent Rejection of High Transimpedance Gain Preamplifier in Infrared Wireless Optical Receiver

Development of an optoelectronic integrated circuit for indoor optical wireless communication systems

Imaging of the Mid-Infrared Focal Plane Array with a Modified Read-Out Circuit.

Circuits for Optical Based Line of Sight Voice Communication

Design of an Amplifying and Conditioning Circuit for Weak Infrared Signal

InP-based monolithic integration of 1.55 um MQW laser diode and HBT driver circuit