Abstract:Using high-strength (HS) materials in steel–concrete composite beams is an efficient approach to reduce the self-weight and to improve the sustainability benefits of such members. Due to a lack of precise knowledge of the ductility of composite beams beyond their first yield as a result of the non-linear response of their constituent materials, a comprehensive investigation is reported herein to quantify the available rotation capacity of composite beams using HS materials when subjected to sagging bending. An advanced three-dimensional finite element model is utilised to calculate the end rotation of single-point-loaded simply-supported composite beams. The model has demonstrated to be adequate and reliable in terms of predicting the flexural strength and load–deflection response by comparisons with numerous experimental results reported elsewhere. As many as 1380 beams with various strengths of steel and concrete as well as a wide range of the degree of shear connection and geometries are modelled, and both solid slabs and composite slabs using profiled steel decking are incorporated. Analyses of this body of data indicate that the depth of the neutral axis is the most essential parameter for determining the available sagging rotation capacity, of which an increased value leads to a lower rotation capacity. The yield strength of the steel also has noticeable effects with higher values resulting in poorer rotation performance. The available rotation capacity is also sensitive to the span-to-depth ratio of the beams. In addition, the effects of varying cross-sectional geometries, different patterns of shear connector distributions as well as of geometric imperfections and residual stresses are clarified, which are shown to be slight and can therefore be ignored. Finally, a non-linear empirical equation is developed to predict the available rotation capacity of composite beams using HS materials, which covers the range of numerical data with satisfactory consistency. The outcomes provide an important basis for evaluating the ductility of composite beams by comparing with the required rotation capacity.

Vertical shear strength of composite beams with compact steel sections. Part Ⅰ: Composite beams subjected to sagging moment

Composite Shear Behavior of Steel-Concrete Composite Beams under Sagging Moment

Experimental Studies on Shear Strength of Steel–Concrete Composite Beams

Reduced Stiffness of Composite Beams Considering Slip and Shear Deformation of Steel

PLASTIC ANALYSIS OF SHEAR BEHAVIOR OF COMPOSITE STEEL-CONCRETE BEAMS

Bending Stiffness of Steel-Concrete Composite Beams Considering Effect of Slip

Experimental Study of Innovative Steel-Concrete Composite Beams under Hogging Moment

Finite Element Modeling of Steel-concrete Composite Beams with Different Shear Connection Degrees

Available rotation capacity of composite beams with high-strength materials under sagging moment

Steel-Concrete Composite Beams Considering Shear Slip Effects

Effective Width of Steel–concrete Composite Beam at Ultimate Strength State

Stiffness and Deflection of Steel–Concrete Composite Beams under Negative Bending

Stiffness and Capacity of Steel–concrete Composite Beams with Profiled Sheeting

Stiffness amplification coefficient for composite frame beams considering slab spatial composite effect

Experimental study of partially shear-connected composite beams with profiled sheeting

Slab spatial composite effect in composite frame systems. II: Equivalent stiffness and verifications

Loading Capacity of Simply Supported Steel-Concrete Composite Slim Beams

Analysis of Equivalent Flexural Stiffness of Steel–Concrete Composite Beams in Frame Structures

Experimental Studies on Behavior of Composite Steel High-Strength Concrete Beams

Numerical modeling on concrete structures and steel-concrete composite frame structures

Shear strength model for steel reinforced concrete composite members: Short columns and deep beams