Abstract:Liquid fuels are good candidates for combustion-based miniature power sources due to their large specific energy. In this study, combustion characteristics of n-C4H10/air mixtures in a tube (ID = 6 mm) partially filled with wire mesh was experimentally explored over an equivalence ratio of phi = 0.5-1.5. In most cases, partially submerged flames and surface flames were observed on the downstream side of the porous media. An external diffusion flame was established under high inlet velocities for fuel-rich mixtures of 1.2 <= phi <= 1.5. The flame with a center convex started to appear at a certain inlet velocity due to the relatively higher local velocity, which was a result of the rolling up method of the wire mesh. Moreover, a lower extinction limit of 0.1 m/s was achieved over 0.9 <= phi <= 1.2, whereas the blow-off limit rose almost linearly up to 0.8 m/s with the equivalence ratio even on the fuel-rich side. The underlying mechanisms for this tendency were comprehensively analyzed from the preheating effect, heat loss effect, volumetric expansion effect as well as the support effect from the external diffusion flame. Furthermore, for an identical inlet velocity, the wall temperature first rose until phi = 1.1 and then decreased when phi > 1.1. Under a constant equivalence ratio, both the maximum wall temperature and the exhaust gas temperature increased with an increasing inlet velocity. However, for an identical inlet velocity, the exhaust gas temperature at low and moderate inlet velocities remained almost invariable versus the equivalence ratio. This was speculated to be the relatively small variation of heat loss ratio versus equivalence ratio. In summary, these findings enriched the knowledge of n-C4H10/air combustion in small tubes partially filled with porous media.

Experimental Study of Small Jet Diffusion Flame of Alcohol with Ceramic Tube As Burner

Experimental Study on the Diffusion Flame from Small Ceramic Tube

Effects of electric field on micro-scale flame properties of biobutanol fuel

An experimental investigation on characteristics of individual flame and multi-jet flame

The Experimental Investigation of Flame Length Influenced by the Central Air Flow of Turbulent Inverse Diffusion Flame

Experimental Study on Characteristics of the Temperature Fields of Inverse Diffusion Flames

Experimental Study on Temperature, Soot Volume Fraction Distributions, and Self-Absorption Effect of a Laminar Diffusion Flame

Experimental study on the radiation characteristic of downward turbulent diffusion jet flame

Effect of Non-Uniform Electric Field on Spherical Flame Characteristics

Experimental investigation on the scale effects on diffusion H2/air flames in Y-shaped micro-combustors

Experimental investigation on flame spread over jet fuel with influence of external heat radiation

Effect of alternating electric field on the combustion and no formation of diffusion flames

Experimental Study on Acoustic Characteristics of Jet Flame with Twin-fluid Air-blast Atomizing Burner

Experimental Study on Combustion Characteristics of N-C4h10/air Mixtures in a Meso-Scale Tube Partially Filled with Wire Mesh

VARIATION OF FLAME SHAPE AND SOOT DEPOSITS BY APPLYING ELECTRIC FIELDS

Effect of DC Electric Field on Turbulent Flame Structure and Turbulent Burning Velocity

Combustion Instability and Emission Characteristics of Spray Flame under Flue Gas Jet

Experimental Study On The Combustion Characteristics Of Liquid Fuel In The Straight Tubes

A Numerical Investigation in Buoyancy Effects on Micro Jet Diffusion Flame

Experimental Study on the Flame Trajectory Evolution of Horizontal Jet Fires under Reduced Pressures

Investigations of Chemiluminescence Characteristics in CH4/O2 Jet Diffusion Flames Impinging on the Flat Plate