Abstract:A hollow cylinder apparatus is used to carry out tests on the principal stress axis rotation for Hangzhou intact soft clay under consolidated undrained conditions, and complex stress path under axisymmetric and three-dimensional stress state is designed. The theoretical results about the impact of rotation rate of the principal stress axis, coefficient of the intermediate principal stress and the initial shear stress on the pore pressure characteristic is validated in tests. The theoretical analyses and test results reveal that the deformation of specimens and the increment of pore pressure generated in the rotation rate of the principal stress axis between 0 and 45 degrees are different from those in the rotation rate of the principal stress axis between 45 and 90 degrees during the rotation of the principal stress axis, and the rotation rate of 45 degrees is the cut-off point. When the coefficient of the intermediate principal stress changes between 0 and 1, the increment of the pore pressure generated decreases first and then increases with the increase of the coefficient of the intermediate principal stress, and the coefficient of 0.5 is the cut-off point, and the impact of the coefficient of the intermediate principal stress on the pore pressure generated is controlled by the level of shear stress in the shearing process. The higher the initial shear stress, the greater the increment of the pore pressure generated in the increasing stage of the initial shear stress and the higher the overall level of the pore pressure in the shearing process. The angle of the major principal stress direction as the control conditions will generate more increment of pore pressure than the initial shear stress as the control conditions in the initial stage of shear stress path including the rotation of the principal stress axis and the increase of the shear stress, and it has a greater impact on the pore pressure generated in the shearing process.

Principal Stresses in Plane Strain State and Their Effects on Engineering

Influence of Intermediate Principal Stress and Principal Stress Direction on Drained Behavior of Natural Soft Clay

Analysis of the Minor Principal Stress Arch Behind Retaining Wall

Analysis on soil arching behind retaining wall

Study on transforming of principal stresses in constant stress ratio plane strain tests

Impact of Shear Stress on Strain and Pore Water Pressure Behavior of Intact Soft Clay under Principal Stress Rotation

Physical Derivation of Effective Stress from Balance Law and Experimental Evidence

Deformation of Intact Soft Clay under Principal Stress Rotation with Effect of Intermediate Principal Stress

Effects of Cyclic Intermediate Principal Stress on the Deformation of Saturated Clay

Influencing Factors about Pore Pressure Generated for Clay under Complex Stress Path

Experimental Study of Stress-Strain Properties of Intact Soft Clay Considering the Change of Principal Stress Direction

Influence Of Stress Path On Secant Modulus Of Soft Saturated Clay

Research on strength and pore pressure of intact clay considering variation of principal stress direction

Influence of Initial State and Intermediate Principal Stress on Undrained Behavior of Soft Clay During Pure Principal Stress Rotation

Research on Stress Path During Excavation Considering Rotation of Principal Stress Axis

Research on loosening earth pressure considering the patterns of stress distribution in loosening zone

Effects of principal stress rotation and cyclic confining pressure on behavior of soft clay with different frequencies

Intact soft clay’s critical response to dynamic stress paths on different combinations of principal stress orientation

Influence of intermediate principal stress on undrained behavior of intact clay under pure principal stress rotation

Hyperbolic Stress-Strain Behaviour of Sandy Soil under Plane Strain Unloading Condition and Its Application on Predicting Displacement-Dependent Active Earth Pressure

Effects of the major principal stress direction respect to the long axis of a tunnel on the tunnel stability: Physical model tests and numerical simulation