Effects of Different Nano Fillers on Electrical Properties of Polyimide Films Under Impulse Voltage
Guangning WU,Xingtao ZHANG,Yan YANG,Xin ZHONG,Xuhui WU,Jian ZHU
DOI: https://doi.org/10.13336/j.1003-6520.hve.20171127002
2017-01-01
Abstract:In order to study the influences of different nano fillers on the electrical properties of PI film,pure PI film,we prepared a 10％ PI/SiO2 film and 10％ PI/Al2O3 film by an in-situ polymerization method.Meanwhile,we tested the conductivity,dielectric spectrum,partial discharge (PD),and corona-resistant property,and determined the microstructure after breakdown by SEM.The results show that the conductivity of PI/SiO2 film is greater than that of PI/Al2O3 film,and the surface conductivity of PI/SiO2 film is 5 times bigger than that of PI/Al2O3 film.The dielectric constant decreases in the sequence of PI/Al2O3 film,PI/SiO2 film,and PI film.The dielectric loss (tanδ) of PI/SiO2 film and PI film first decrease and then increase with the increase of frequency.The tanδ of PI/Al2O3 film is the highest after 6 KHz.The tanδ-f curve of PI/Al2O3 film turns out a peak at 200Hz caused by relaxation of space charge.The partial discharge inception voltage and corona resistance time decrease in the sequence of PI/SiO2 film,PI/Al2O3 film,and PI film,but the change tendency of average amplitude of PD is on the contrary.There are some micro holes and gaps on the surfaces of the three films.The results indicate that the interface volume fraction and nanoparticles polarity are the main reasons for differences between the electrical properties of PI/SiO2 film and PI/Al2O3 film.