Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

Numerical Simulation on Motion of Two Underwater Bubbles Using Level Set Method

Numerical simulation on motion of bubble under water

Numerical Investigation of Multi Rising Bubbles Using a Coupled Level Set and Volume of Fluid (CLSVOF) Method

Experiment and Numerical Simulation of the Motion of Bubble Swarm in a Bubble Column

Development of a Mass-Preserving Level Set Redistancing Algorithm for Simulation of Rising Bubble

Simulation of Tracking the Fluid-Fluid Interface with the Level Set Method

Numerical Simulation of Incompressible Interfacial Flows by a Level Set Re-Distancing Method with Improved Mass Conservation

Numerical Simulation of Water Entry of Two-Dimensional Structures with Complex Geometry Using a CIP-based Model

Three-Dimensional Numerical Simulation of Air Exhausted from Submerged Nozzles

Simulation of Bubbles

Numerical Investigation Of The Interaction Mechanism Of Two Bubbles

Study on the interactions between two identical oscillation bubbles and a free surface in a tank

Experimental and Numerical Study on the Bubble Dynamics Near Two-Connected Walls with an Obtuse Angle

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Numerical simulation of bubble wakes with mixed scales of underwater vehicles

Numerical Analysis of Microbubble Rising in an Oil–water Liquid Layer under Gravity Based on Three-phase Field Method

Direct numerical simulation of deformable rising bubbles at low Reynolds numbers

Numerical Simulation of a Sessile Bubble Beneath a Horizontal Solid Wall in Liquid

Numerical Simulation on Moving Shock Interacting with Gas-water Interface

Theoretical and Numerical Studies on the Bubble Collapse in Water

Numerical simulations of bubbly flows in a vertical periodic channel