Abstract:Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, Ahead of Print. To improve the dynamic load-sharing performance and achieve lightweight, the twin rotors concentric face gear power-split transmission system (TRFGPSTS) was optimized. The gear tooth matching conditions of the system based on the design characteristics of power flow closed-loop and virtual constraint configuration of the system are established, and the basic parameters of each gear meet the requirements of the system load-sharing layout and synchronous meshing of each branch movement are calculated. Based on the lumped mass parameter method, combined with the calculation results of gear tooth matching, the 45-DOF bending torsional coupling dynamic model of the system was established considering time-varying meshing stiffness, support stiffness, manufacturing and installation errors, and other factors, and the influence of each factor on the dynamic load-sharing performance of the system was analyzed. Combined with the influence law of various factors, a multi-objective dynamic load-sharing optimization design model was established with the best dynamic load-sharing performance and the minimum system quality as the objective function. Through the weighted combination method, the global optimal solution of the system optimization design was determined, and the influence of each parameter on the optimization objective function was analyzed. The correctness of the results was verified by using the genetic algorithm based on Pareto frontier distribution. The results show that the dynamic load-sharing characteristics of the system become worse with the increase of error and torsional stiffness, and are more sensitive to the influence of various error parameters. The optimization process focuses on the geometric parameters such as the Module, the teeth Number, the Pressure angle, and the Tooth width of each gear, which can reflect the degree of influence on the dynamic load-sharing and lightweight of the system. After optimization, the dynamic load sharing coefficient (DLSC) was reduced to 1.017, and the overall geometric volume was reduced to 1.473 × 108 mm3. It provides a theoretical basis for the design and research of a new type of helicopter power transmission system with a compact structure, good maneuverability, and high reliability.

Sickle Mechanism of Combined Harvesters of Drive Planetary Gear Train Multi-objective Optimization

Optimization Synthesis of Hybrid Six-Bar Mechanism with Non-Circular Gear Constraints

Multi-objective optimization of helical gear transmission geometric parameters using MOPSO

Optimal Design of Planetary Reducer of Electric Actuator base on NSGA-II

Optimization of teeth distribution for promote gearbox used in jack-up offshore platforms using improved genetic algorithm

Multi-objective optimization design of dual-cone double enveloping hourglass worm gear pair

Reliability Design of Two-Stage Planetary Gear Wheel Hub Reducer based on Multi-Objective Optimization

A Novel Multi-Objective Dynamic Reliability Optimization Approach for a Planetary Gear Transmission Mechanism

Multi-Objective-Layered Optimization of a Magnetic Planetary Gear for Hybrid Powertrain

Multi-objective optimization of cycloidal gear based on segmental modification of pressure angle

Multi-objective optimization design of cycloid pin gear planetary reducer

Multi-Objective Optimization Design of 6-UPS Parallel Mechanism Based on Taguchi Method and Entropy-Weighted Gray Relational Analysis

Multi-objective optimized design for modified cycloid-pin gear drive mechanism based on load-bearing capacity

Multi-object Optimization of Machining Scheme Based on Improved Particle Swarm Optimization Algorithm

Kinematical Properties and Parameter Optimization of Separating-Planting Mechanism With Double Control Unit

Multi-Objective Optimization and Test of a Tractor Drive Motor

Double-stage multi-objective optimized design for cycloid pinwheel reducer based on genetic algorithm

Optimization design of load-sharing and light weight of the twin rotors concentric face gear power-split transmission system based on gear tooth matching condition

Multi-objective Function Optimization of 2-RPU&2-SPS Parallel Mechanism Based on Adams

Optimal Design of Hydraulic Excavator Working Device Based on Multiple Surrogate Models

Parameter optimization design of two-planetary-gear power-split hybrid system configuration using the RAD-MOPSO algorithm