An effective anisotropic visco-plastic model dedicated to high contrast ductile laminated microstructures: Application to lath martensite substructure
V. Rezazadeh,F. Maresca,J.P.M. Hoefnagels,M.G.D. Geers,R.H.J. Peerlings
DOI: https://doi.org/10.1016/j.ijsolstr.2024.112757
IF: 3.667
2024-03-09
International Journal of Solids and Structures
Abstract:In particular types of layer- or lamellar-like microstructures such as pearlite and lath martensite, plastic slip occurs favorably in directions parallel to inter-lamellar boundaries. This may be due to the interplay between morphology and crystallographic orientation or, more generally, due to constraints imposed on the plastic slip due to the lamellar microstructural geometry. This paper proposes a micromechanics based, computationally efficient, scale independent model for a particular type of lamellar microstructures containing softer lamellae which are sufficiently thin to be considered as discrete slip planes embedded in a matrix representing the harder lamellae. Accordingly, the model is constructed as an isotropic visco-plastic model which is enriched with an additional orientation-dependent planar plastic deformation mechanism. This additional mode is activated when the applied load, projected on the direction of the soft films, induces a significant amount of shear stress. Otherwise, the plastic deformation is governed solely by the isotropic part of the model. The response of the proposed model is assessed via a comparison to an infinite periodic two-phase laminate. It is shown that the yielding of the model follows the same behavior as the reference model. The proposed model is highly anisotropic, and the degree of anisotropy depends on the contrast between the slip resistance of the planar mode versus that of the isotropic part. The framework is then applied to the substructure of lath martensite with thin films of inter-lath retained austenite, and exploited in a mesoscale simulation of a dual-phase steel microstructure. The results are compared with those of a standard isotropic model and a full crystal plasticity model which does not have the additional planar plastic mechanism. Predictions made with the proposed model show distinct differences compared with the crystal plasticity results, while keeping the computational cost comparable to that of the isotropic model – and significantly lower than that of the crystal plasticity simulation.
mechanics