Abstract:Introduction: Near surface temperature and thermal behavior not only provide information for testing models for thermal evolution of the Moon, quantifying depth at which volatiles might be stable, but are also important for system design for human and robotic exploration of the Moon. Since 1960s, extensive studies about near surface temperature of the Moon were conducted by using theoretical simulation, in situ measurements, and remote sensed observations at in-frared and radio band [1-4]. However, most of previous observations are at infrared band that only contains surface information within 1 µm, and there is almost no systematical study about subsurface temperature. In China's ChangE 1 and 2 missions, four channel microwave radiometers (MRM) were used to measure thermal emission from the lunar surface, from which near surface temperature down to a depth of several meters can be estimated globally [5, 6]. In this study, near surface temperature of the Moon is investigated using ChangE 2 microwave radiometer data. First, factors that affecting high-frequency brightness temperature (TB), such as surface slope, solar albedo, and dielectric constant of regolith, are analyzed. Then, using a two-layer regolith model, thermal emission from lunar surface at high frequency is mod-eled based on radiative transfer theory. Using this model, mean diurnal temperatures for lunar surface and subsurface are inverted from mean diurnal brightness temperature at 19.35 and 37 GHz. Factors that Affecting Lunar Brightness Temperatures: At microwave band, thermal emission from lunar surface depends mainly on depth-dependent temperature and dielectric constant of regolith. During lunar daytime, the steady state surface temperature can be obtained by energy balance between solar radiation and infrared thermal radiation, which is known as Rac-ca's model [7]. Surface slope changes local incidence angle of solar radiation, which results in a change in physical temperature. On the other hand, solar albedo affects the absorbed solar energy by lunar surface, causing a change in surface temperature. As a result of temperature dependent thermal emission, these two factors can affect the observed TB from lunar surface. As an example, Figure 1 shows the effect of surface slope (a) and solar albedo (b) on the observed TB at 37 GHz for lunar noon. The black lines in Figure 1a and 1b indicate the observed TB by CE-2, with their ground tracks represented by the black lines in Figure 1c. The red lines represent the steady state surface temperature that estimated from Racca's model, and the blue lines …

The measurement in lunar surface thermal environment

Thermal modeling of the lunar regolith at the Chang'E‐4 landing site

Numerical Analysis of Thermal Environment of Lunar Surface

Lunar Surface Temperature and Emissivity Retrieval from Diviner Lunar Radiometer Experiment Sensor

High Frequency Thermal Emission from the Lunar Surface and Near Surface Temperature of the Moon from Chang’E-2 Microwave Radiometer

In Situ Photometric properties of Lunar Regolith Revealed by Lunar Mineralogical Spectrometer on board Chang'E‐5 Lander

Performance evaluation of lunar penetrating radar onboard the rover of CE-3 probe based on results from ground experiments

Analysis of Microwave Brightness Temperature of Lunar Surface and Inversion of Regolith Layer Thickness:Primary Results of Chang-E 1 Multi-Channel Radiometer Observation

Low Lunar Surface Temperature Retrieval from LRO Diviner Radiometer Observation Data

Analysis of high-frequency brightness temperature of lunar surface from chang ’ e-2 microwave radiometer and investigations of mean diurnal temperature of regolith layer

Chang'E‐4 rover spectra revealing micro‐scale surface thermophysical properties of the Moon

Photometric Characteristics of Lunar Soils: Results from Spectral Analysis of Chang'E-5 In Situ Data Using Legendre Phase Function

Temperature Prediction of Icy Lunar Soil Sampling Based on the Discrete Element Method

Calibration of the space-borne microwave humidity sounder based on real-time thermal emission from lunar surface

Design of Space Thermal Environment Monitoring Instrument

A thermal control system for long-term survival of scientific instruments on lunar surface

Chang'E‐5 In Situ Spectra Reveal Photometric Properties of the Lunar Surface

Design and Development of Energy Particle Detector on China's Chang'e-7

Thermal Removal Method for Chang'e-5 Multispectral Data Using a Heat Conduction Model and Real Terrain.

Celestial body irradiance determination from an underfilled satellite radiometer: application to albedo and thermal emission measurements of the Moon using CERES

A Measurement Method for Cislunar Spacecraft Based on Connected Element Interferometry and BeiDou-3 Interplanetary Link in Future Lunar Exploration