Abstract:In the study of coal mining, the position and posture, the working status, and the straightness of the hydraulic support are critical to the safety of the coal mine. To detect and control the position of a hydraulic support, a model for solving the self-position and posture and a model for solving the relative position and pose of a hydraulic support based on the principle of three points determining a plane in space were established. Then, with the help of particle swarm optimization algorithm and Bang-Bang control algorithm, the hydraulic support position and the posture detection and control system are constructed. Finally, according to the requirements of sensor data collection and online monitoring of the position and posture of hydraulic support, a hydraulic support posture detection and control system is developed, and the simulation experiments of hydraulic support cylinder movement sample collecting, hydraulic support following motion and hydraulic support independent following machine are carried out on the self-developed three-machine intelligent control simulation experiment platform of the working face. However, the test under this simulation platform did not add the load of the top beam. The results show that the self-pose solution model and the relative-pose solution model of the hydraulic support can be used to quickly monitor the position and posture of the hydraulic support group. In the hydraulic support cylinder following motion movement, the largest following error of each cylinder is the balance cylinder, and its maximum error is 2.6 mm. In the hydraulic support independent following machine simulation, the maximum motion error of the support base is 2.2 mm. The position and posture detection and control system developed for hydraulic support can realize accurate detecting and control the position and posture of hydraulic support, as well as meet the requirements for industrial applications.

Position detection device design of the position-controller for construction hoist

Development of tower crane model dead-load test device in structural design competition

A Combined Nonlinear Pid Control and Cross-Coupled Pre-Compensation Control in Hydraulic Excavator

Position and Attitude Precision Analysis of Segment Erector of Shield Tunneling Machine

New Challenges In Precision Positioner Development

Research and Application of Intelligent Control Method of Small Type Loader Actuator

Positioning speed and precision control of a segment erector for a shield tunneling machine

Positioning Precision and Impact Force Control of Segment Erector for Shield Tunneling Machine

Modeling and Control of General Hydraulic Excavator for Human-in-the-loop Automation

Design and test analysis of rotary electro-hydraulic control system for a segment assembly test bed

Research on the Position-Controller for Lifted Hoist Based on Single-Chip Microcomputer

Design and Cooperation Control Analysis of a Coarse-Fine Dual Stage Drive Positioning System

Modeling and H∞ Position Control of a Spreader in the Gantry Crane

Ultrasonic Motor Position Control Using Hall Device

A Position Control Based on Active Disturbance Rejection Controller Considering Parameter Variations of Harmonic Drive Gear Systems

Drive System Design and Error Analysis of the 6 Degrees of Freedom Segment Erector of Shield Tunneling Machine

Design of Load's Anti-Swing Control System of Overhead or Gantry Crane Based on DSP

Research on Intelligent Control System of Hydraulic Support Based on Position and Posture Detection

Crane intelligent control system based on visual location

A New Position Detection and Status Monitoring System for Joint of SCARA

Study on position-controller for elevator based on AT89C52