Effect of backwashing on perchlorate removal in fixed bed biofilm reactors

Young Chul Choi,Xu Li,Lutgarde Raskin,Eberhard Morgenroth
DOI: https://doi.org/10.1016/j.watres.2007.01.025
IF: 12.8
2007-01-01
Water Research
Abstract:The influence of backwashing on biological perchlorate reduction was evaluated in two laboratory scale fixed bed biofilm reactors using 1- or 3-mm glass beads as support media. Influent perchlorate concentrations were 50μg/L and acetate was added as the electron donor at a concentration of 2mg C/L. Perchlorate removal was evaluated at various influent dissolved oxygen (DO) concentrations. Complete perchlorate removal was achieved with an influent DO concentration of 1mg/L resulting in bulk phase DO concentrations below the detection limit of 0.01mg/L. The influence of increasing influent DO concentrations for 12h periods was evaluated before and after individual backwash events. Partial perchlorate removal was achieved with an influent DO concentration of 3.5mg/L before a strong backwash (bulk phase DO concentrations of approximately 0.2mg/L), while no perchlorate removal was observed after the strong backwash at the same influent DO level (bulk phase DO concentrations of approximately 0.8mg/L). The immediate effect of backwashing depended on influent DO concentrations. With influent DO concentrations of 1mg/L, strong backwashing resulted in a brief (<12h) increase of effluent perchlorate concentrations up to 20μg/L; more pronounced effects were observed with influent DO concentrations of 3mg/L. Daily weak backwashing had a small and, over time, decreasing negative influence on perchlorate reduction, while daily strong backwashing ultimately resulted in the breakdown of perchlorate removal with influent DO concentrations of 3mg/L.
What problem does this paper attempt to address?