Abstract:Granites are generally the final products of crustal anatexis. The composition of the initial melts may be changed by fractional crystallization during magma evolution. Thus, it is crucial to retrieve the temperature and pressure conditions of crustal anatexis on the basis of the composition of the initial melts rather than the evolved melts. Here we use a suite of similar to 46-41 Ma granites from the Himalayan orogen to address this issue. These rocks can be divided into two groups in terms of their petrological and geochemical features. One group has high maficity (MgO + FeOt = 2-4wt%) and mainly consists of two-mica granites, and is characterized by apparent adakite geochemical signatures, including high Sr concentrations and Sr/Y and La/Yb ratios, and low concentrations of heavy rare earth elements and Y. The other group has low maficity (MgO + FeOt <1 wt%) and consists of subvolcanic porphyritic granites and garnet/tourmaline-bearing leucogranites. This group does not possess apparent adakite signatures. The low-maficity group (LMG) has lower MgO + FeOt contents and the high-maficity group (HMG) has higher Mg# compared with initial anatectic melts determined by experimental petrology and melt inclusions studies. Petrological observations indicate that the HMG and the LMG can be explained as a crystal-rich cumulate and its fractionated melt, respectively, such that the initial anatectic melt is best represented by an intermediate composition. Such a cogenetic relationship is supported by the comparable Sr-Nd isotopic compositions of the two coeval groups. However, these compositions are also highly variable, pointing to a mixed source that was composed of amphibolite and metapelite with contrasting isotope compositions. We model the major and trace element compositions of anatectic melts generated by partial melting of a mixed source at four apparent thermobarometric ratios of 600, 800, 1000 and 1200 degrees C GPa(-1). Modeling results indicate that melt produced at 1000 degrees C GPa(-1)best matches the major and trace element compositions of the inferred initial melt compositions. In particular, a binary mixture generated from 10 vol% partial melting of amphibolite and 30 vol% melting of metapelite at 850 +/- 50 degrees C and 8.5 +/- 0.5 kbar gives the best match. Therefore, this study highlights that high thermobarometric ratios and subsequent fractional crystallization are responsible for the generation of the apparent adakitic geochemical signatures, rather than melting at the base of the thickened crust as previously proposed. The thermal anomaly responsible for the Eocene magmatism in the Himalayan orogen was probably related to asthenosphere upwelling in response to rollback of the subducting Neo-Tethyan oceanic slab at the terminal stage of continental collision between India and Asia. As such, a transition in dynamic regime from compression to extension is necessary for the generation of high thermobarometric ratios in continental collision zone. Therefore, after correcting for potential effects of fractional crystallization and crystal accumulation on melt composition, granite geochemistry coupled with thermodynamic modeling can better elucidate the petrogenesis of granites and the geodynamic mechanisms associated with anatexis at convergent plate boundaries.

Estimating Influence of Crystallizing Latent Heat on Cooling-Crystallizing Process of A Granitic Melt and Its Geological Implications

Estimate of Influence of U-Th-K Radiogenic Heat on Cooling Process of Granitic Melt and Its Geological Implications

On the Time Elapsed from Magma Emplacement to Crystallization-Solidification of Granites and Its Tectonic Implication: Taking the Qitianling Granite Batholith of Nanling Range in Sourth China As an Example

Crystallization And Melt Extraction Of A Garnet-Bearing Charnockite From South China: Constraints From Petrography, Geochemistry, Mineral Thermometry, And Rhyolite-Melts Modeling

Low-temperature crystallization of granites and the implications for crustal magmatism

Magma-Dynamic Evidence for Indosinian Cycle Emplacement of the Qitianling Granite Batholith in Nanling Range,Sourth China:Reply and Discussion to Comments by Prof.Zhu Jinchu Et Al

New Thinking, Method and Calculated Examples of High Temperature Thermochronology of Granite Plutons

Tensile Microcracking Behavior of Granites after High Temperature Treatment by Considering the Effect of Grain Size and Mineralogical Composition

Influence of Cooling Speed on the Physical and Mechanical Properties of Granite in Geothermal‐related Engineering

An isotope study on the cooling history of the Dalongshan granitic massif and its bearing on mineralizing process

Estimation of an Ephemeral Cooling for Silicic Magma Reservoirs Using Thermal Simulation

Temporal Relationship Between Granite Cooling and Hydrothermal Uranium Mineralization at Dalongshan in China: A Combined Radiometric and Oxygen Isotopic Study

The Effects of Source Mixing and Fractional Crystallization on the Composition of Eocene Granites in the Himalayan Orogen

Thermal effects on prediction accuracy of dense granite mechanical behaviors using modified maximum tangential stress criterion

Laboratory Investigation on Physical and Mechanical Behaviors of Granite after Heating and Different Cooling Rates

Diapirs of crystal-rich slurry explain granite emplacement temperature and duration

Significance of Selective Crystal Entrainment and Differential Crystal‐melt Separation in Petrogenesis of Granites from the Tongbai Orogen

Investigation of the Mechanical and Permeability Evolution Effects of High-Temperature Granite Exposed to a Rapid Cooling Shock with Liquid Nitrogen

Impacts of different cooling methods on the dynamic tensile properties of thermal-treated granite

Experimental study on the physical and mechanical variations of hot granite under different cooling treatments

Magma-Dynamical Evidence for Indo-Sinian Emplacement of the Uranium-Bearing Jinjiling Granite Batholith and Its Tectonic Implication