Abstract:This paper presents the analysis and design of a novel traction control system (TCS) based on sliding-mode control (SMC) and maximum transmissible torque estimation (MTTE) technique, which is employed in four-wheel independent drive electric vehicles (EVs) without detecting the vehicle velocity and acceleration. The original MTTE technique is effective with regard to the antislip control; however, it cannot sufficiently utilize the adhesive force from the tire–road surface. In the proposed TCS algorithm, only front wheels are equipped with the MTTE technique, while rear wheels are equipped with the SMC technique. As a result, the front wheel is critically controlled by the MTTE technique. Thus, its rotary speed can be used to approximately estimate the chassis velocity and acceleration, which are key input parameters of the SMC. The rear wheel slip ratio can be therefore controlled by the SMC which is robust against uncertainties and disturbances of parameters for exploiting more transmissible friction force. In addition, the stability of MTTE is analyzed in this paper because an important parameter is neglected in the original MTTE technique. As a result, the stability condition is changed, and the MTTE is modified in the proposed TCS according to the new conclusion. A half four-wheel drive (4WD) EV model is initially built using matlab/simulink. This paper investigates the proposed TCS for various adhesive conditions involving abrupt change in road friction. Compared with the original MTTE technique, the comprehensive performance, particularly the acceleration ability, is significantly improved by the proposed controller. The simulation result validates the effectiveness and robustness of the proposed TCS.

A Research on Optimal-Slip-Ratio-Identification-Based Traction Control System Implemented on EV

Tire-road friction estimation and traction control strategy for motorized electric vehicle

A Novel Traction Control Strategy Based on Optimal Slip Ratio Control for Electric Vehicle

Investigation into Electronic Differential Strategies Based on Differential Driving

A Model Predictive Control Approach With Slip Ratio Estimation for Electric Motor Antilock Braking of Battery Electric Vehicle

Practical active traction control for independent‐wheel‐drive electric vehicle based on slip‐ratio threshold determination

Wheel Slip Control Using Sliding-Mode Technique and Maximum Transmissible Torque Estimation

Optimal allocation of tire force based on vehicle stability

Design of slip-based traction control system for EV and validation using co-simulation between Adams and Matlab/Simulink

Research on Anti-Skid Control Strategy for Four-Wheel Independent Drive Electric Vehicle

Traction Control System for EV Based on Modified Maximum Transmissible Torque Estimation

An Improved Adaptive Sliding Mode Control Approach for Anti-Slip Regulation of Electric Vehicles Based on Optimal Slip Ratio

Nonlinear wheel-slip dynamics of battery electric vehicle for anti-lock brake system control by traction motor

Slip ratio estimation of electric wheels based on tire force and road conditions

Dynamic Load Emulation of Slip Ratio Control in Anti-lock Braking of a Front-axle-drive Electric Vehicle

Electric vehicle braking control based on a slip ratio trial method

ABS Control Strategy for Electric Vehicles Driven by Four Wheel Motors

A Nonlinear Control Scheme for the Traction Problem in EVs with Unknown Parameters

A Design Approach for Observer-based Robust Traction Control with PMSM

Slip ratio control based on adaptive fuzzy sliding mode for vehicle with an electromechanical brake system

Hierarchical Traction Control for Hybrid Electric Vehicle and Hardware-in-loop Test