Abstract:In this paper, we present investigation of a direct-current discharge with a gridded anode from the point of view of using it as a means of creating plasma coating that could efficiently absorb incident electromagnetic (EM) waves. A single discharge cell consists of two parallel plates, one of which (anode) is gridded. Electrons emitted from the cathode surface are accelerated in the short interelectrode gap and are injected into the post-anode space, where they lose acquired energy on ionization and create plasma. Numerical simulations were used to investigate the discharge structure and obtain spatial distributions of plasma density in the post-anode space. The numerical model of the discharge was based on a simple hybrid approach which takes into account non-local ionization by fast electrons streaming from the cathode sheath. Specially formulated transparency boundary conditions allowed performing simulations in 1D. Simulations were carried out in air at pressures of 10 Torr and higher. Analysis of the discharge structure and discharge formation is presented. It is shown that using cathode materials with lower secondary emission coefficients can allow increasing the thickness of plasma slabs for the same discharge current, which can potentially enhance EM wave absorption. Spatial distributions of electron density obtained during simulations were used to calculate attenuation of an incident EM wave propagating perpendicularly to the plasma slab boundary. It is shown that plasma created by means of a DC discharge with a gridded anode can efficiently absorb EM waves in the low frequency range (6–40 GHz). Increasing gas pressure results in a broader range of wave frequencies (up to 500 GHz) where a considerable attenuation is observed.

Broadband Absorption of Electromagnetic Waves in Collisional Plasma

Resonant Absorption of Incident Electromagnetic Waves in Collisional Inhomogeneous Plasma Slabs

Research on the Reflection Characteristics of the Broadband Electromagnetic Wave in Nonuniform Plasma

Propagation of Broadband Terahertz Pulses Through a Dense-Magnetized-collisional-bounded Plasma Layer

Total Absorption of Electromagnetic Radiation in Overdense Plasma

Reflection Properties of Electromagnetic Wave in a Bounded Plasma Slab

Collision effects on propagation characteristics of electromagnetic waves in a sub-wavelength plasma slab of partially ionized dense plasmas

A Calculation Method of Electromagnetic Wave Reflection in Plasma Sheath Environment

Propagation Properties of Broadband Terahertz Pulses Through a Bounded Magnetized Thermal Plasma

The Attenuation of Electromagnetic Waves by Inhomogeneous Spherically Symmetric Plasma

A Model of the Absorption of Electromagnetic Waves by Weakly Ionized Plasma and the Numerical Calculation

Properties of Terahertz Waves Propagation in a Bounded Plasma Slab with High Collision Frequency and High Density

Experimental Investigation on Electromagnetic Wave Transmission Characteristic in the Plasma High Temperature Gas

Theoretical and Experimental Studies of Electromagnetic Wave Transmission in Plasma

Numerical Simulation and Analysis of Electromagnetic-Wave Absorption of a Plasma Slab Created by a Direct-Current Discharge with Gridded Anode

The multi-peak point phenomenon of broadband microwave reflection caused by inhomogeneous plasma

Study on the electromagnetic waves propagation characteristics in partially ionized plasma slabs

Excitation Of Surface Plasmons Achieve Total Absorption Of Electromagnetic Wave In Overdense Plasma

Optimal Density Profile of the Plasma Layer Shielded by A Conducting Surface for the Absorption of Electromagnetic Waves

Research on Reflection Mechanism of Nonuniform Plasma

Total Absorption of an Electromagnetic Wave by an Overdense Plasma