Slow Release Characteristics of the Low Molecular Weight Polylactic Acid-Coated Urea and Its Reduction Effects on Soil Ammonia Volatilization

LI Dan,SUN Jian-bing,NI Wu-zhong
DOI: https://doi.org/10.3864/j.issn.0578-1752.2012.02.010
2012-01-01
Abstract:【Objective】 This paper presented an approach for preparing low molecular weight polylactic acid (PLA)- coatedslow-release urea. The release behavior and reduction of ammonia volatilization after the coated urea added into soil were studied. 【Method】 By spouted-spraying methods, film coated urea fertilizers were prepared with two types of low molecular weight PLA(relative molecular weight-RMW5000 and RMW10000) respectively, retreated with paraffin wax as sealant or not, thus four typesof coated urea were obtained. The structure of coating film was observed by scanning electronic microscopy (SEM), nitrogen releasewas investigated by a soil column leaching method, and ammonia volatilization was determined with an incubation experiment. 【Result】 SEM images showed that both of RMW5 000 and RMW10 000 PLA as a film coated on the surface of granular urea.Paraffin wax used as a sealant could fill up the micro holes or cracks in the coating film. Under the same nitrogen dose added, theamounts of total nitrogen leaching from soil column of the treatments with coated urea were significantly lower than that of thenormal urea treatment, implying that the slow-release effectiveness of coated urea is clear. In the incubation experiment, it was foundthat nitrogen losses through ammonia volatilization of the treatments with coated urea were significantly lower than that of the ureatreatment. 【Conclusion】 Low molecular weight PLA coated urea is a new environment-friendly type of slow-release fertilizer, andits application in sustainable agriculture is prospective.
What problem does this paper attempt to address?